Different Radio connector on new Yeti - Does anyone have details?

[Rayman]

Hi all,

 

New Yeti 2.0 150 TDI SE 4x4, Bolero Radio, Park - Assist & Smartlink.

 

I was planning to fit the Columbus sat-nav retained from my previous Yeti but the connector on the new car is different so not possible. Somewhat disappointed as I also have a new (OEM) Yeti reversing camera that I intended to fit at the same time. As things stand it should be possible to use my phone via Smartlink for nav as that option was ordered as a back up plan (should have ordered the camera option as well). It may also be possible connect the camera via the new connector so am hoping that someone can advise where to find the pin connections for this new connector or tell me I'm wasting my time, either way I would appreciate some advice here. I do have a photo of the new connector but not sure if (or how) it can be added to this posting.

 

Many thanks.

[Rayman]

Hi all,

 

New Yeti 2.0 150 TDI SE 4x4, Bolero Radio, Park - Assist & Smartlink.

 

I was planning to fit the Columbus sat-nav retained from my previous Yeti but the connector on the new car is different so not possible. Somewhat disappointed as I also have a new (OEM) Yeti reversing camera that I intended to fit at the same time. As things stand it should be possible to use my phone via Smartlink for nav as that option was ordered as a back up plan (should have ordered the camera option as well). It may also be possible connect the camera via the new connector so am hoping that someone can advise where to find the pin connections for this new connector or tell me I'm wasting my time, either way I would appreciate some advice here. I do have a photo of the new connector but not sure if (or how) it can be added to this posting.

 

Many thanks.

UPDATE: There have been no replies to this topic but I have now made progress thanks to satnavdeals who originally supplied the Columbus sat-nav.  I obtained a 52 pin Quadlock to 40 pin Quadlock adapter cable from Spain and the Columbus RNS 510 is now working fine in my new Yeti. I understand some VCDS changes in the CAN bus installation list are required but my unit worked straight away without any reprogramming so have not been done.

I have yet to fit the reversing camera as I first need to establish how to route the cables between tailgate and dashboard but that's for another topic. 

Edited 4 September, 2016 by Rayman

[Sibu]

Does anyone know for the  external antenna located on the roof of the Yeti, the diameter of the male connector ?  Is this 6 mm or 5mm