Octavia VRS mk I replacing FPR pipe after boost gauge install

[KWhite95]

Hi guys after installing a boost gauge and getting fed up with boost pressure issues ive decided to take it out and replace the fuel pressure regulator pipe I cut to insert the T-piece, does anyone know or have a link to the actual pipe I need or some pipe I could use instead, thanks. (found this picture on another post which labels the pipe I need) 

[Leeboy]

Nothing special needed here, but not thin walled silicone tubing. This pipe goes from the regulator to the dump valve if I recall correctly.

For mine is used some 4mm ID fuel line hose from Halfords which does the job just fine.

[rsdanne]

actualy it goes  straight to the intake manifold from the fpr

 

 i just replaced mine just a normal fuel line hose that is 4mm inside that can take some heat i belive mine is good for about 90 degrees celsius

 

best regards

[Leeboy]

actualy it goes straight to the intake manifold from the fpr

Yes you're right, when I looked again, DV line goes to manifold as does FPR. Both inlets sit next to each other at the end of the manifold.