mixifix

Mechanic had a road test it's the front roll bar the niose resonates down car,water in boot was left back light unit slightly loose

Hi bought a 2008 fabia 3 month ago 57,084 miles on clock, running well issues I have it's developed a rumble type noise back end towards passenger side. So after jacking up pulling tugging wheel exhaust and suspension finding nothing, decided to empty all boot out issue two pops up water in spare wheel well. Any pointers would be good thanks

Well who would have thought it , not me pointy end of safety pin in hole no more dribbles thank you

Upgraded from mk 1 to a 2008 mk 11 only thing so far is when I use the rear wash it squirts and wipes as it should When it has finished it dribbles on a little any ideas please

Upgraded from mk 1 to a 2008 mk 11 only thing so far is when I use the rear wash it squirts and wipes as it should When it has finished it dribbles on a little any ideas please

My boot would not open checked over looked fine lay in boot with car all closed up pressed unlock on keypad the piston part of this did not move

Yes some these so it sounds about right thanks

Bought a fabia mk1 just over a year ago its a 55 plate now got just over 44,000 Miles on clock got problem with central locking unlocked car locks itself any help would be good about a month ago changed batteries in remotes

Just got one PIC how do I post it

According to RAC man mine has been modified them wire should go onto a block mine hasn't got one it has a round plastic bit the connection went down middle of can't be put back now needs starter motor thanks skoda

Will have another look can't remember seeing the black square your showing mines a 55 plate 1.2 petrol engine

Thin red under battery tray

After checking battery 13.25 vaults and going up took it out and tray found a Ted wire snapped off looked all round not sure were to connect it has female spade with a bit of male init

When ignition turned all lights show when turned to start all lights go out ju.St get a whirrr Checked battery terminals all tight,going to check rest today will update later