sparky93

boonkers, i was just thinking of this one, and thought i would post here, and seems i did already, abit no views :(

Just reading some old material, where is the last one now? Recall SN used to have it...but now whereabouts unknown, and not seen it at any shows......

I know its a old thread, but could do with a bit of info on how to bypass feli's imob. starts runs for about 2 secs and cuts out. Its for pmol.

Also saw this on flea-bay, hope its ok, and look after it well :-)

only works with key in the lock and holding it till the window stops or you let go. Works for opening and closing. There is a extra module require for the remote to do the same.

was easy to do, but i cant remember, the screws x4 i think, are easy to spot, 2 at bottom in front of gearlever, after gaitor trim is unclipped, and theother 2 are inside the ashtray hole nr top. mind the little lamp holder/bulb.

hope its not like mine, http://briskoda.net/forums/topic/153339-alh-tdi-prob/page__p__1903542entry1903542

i did think of that, but i disregarded it. OP didnt mention the flashing yellow key symbol, and it kills the engine 2 seconds after it fires.

more likely to be the keyswitch itself, part not contacting that feeds the starter solonoid. dmm will show that. :-) if u'r on a hill, bump it.

mine was lot worse, its in having hg done, but still think its cracked.

what was that filler item you refer to? wherre did you get it? weblink? cheers :-)

I wonder where my old t reg is. dvla shows its still taxed. T715LAC

leaky pollen filter housing/ scuttle full of leaves. Good luck getting the black covers off, cant shift mine.

I managed to get the plug off just. wow was it a bugger. I started car and no smoke and easy fired up, but i will leave it now till 4pm when it will usually smoke. Hope to remember to plug it back in when i drive haha.

Hi, how the.... do you unplug the dam thing, the connector just wont budge. Want to disconnect to try see if it cold starts better as its a bit hard and smokey spluttery when cold. ok rest of time when hot. It was hard to get the connectoer off the sensor on pipe just from the air box. had to get screw driver to prise it off. [pasted to a few thread ends]