matt_j

Any info or how to's in this would be great, need to change the elements on the driver's seat, cheers

Fault found! Scanned with my friends code reader and the seat seems to have tripped out, deleted the code and it's working again, the fault was heat temperature sensor short circuit so if it happens again it'll be the base pad need changed as this has the thermostat in it

Don't know why I'm bothering to update as help seems few and far between on this subject, checked what I assume to be the correct wires from the base heater and back heater and I'm getting 2.0 ohms and 3.2 so my guts telling me it's the thermostat in the base heater that's toast, will report back if I get to the bottom of it, so you don't have the same grief as me 👍

Does anyone know how to check the elements? The wire colours and the expected resistances? Had a quick look this morning, seat out job for me and get to anything and the wiring is all really tight and inaccessible

Checked that budd, it's fine 👍

Checked today no code errors 🤦

Wirings good, horrible feeling it's a burnt out element ? As in code reader for fault codes?

Evening all, sorry if this has been done to death but my drivers seat heater has stopped working, the cars light up on the switch briefly then go out, passenger seat works ok so I'm guessing that rules out the fuse

Hi, pads virtually new, brake fluid changed 2 years ago for motul stuff, 47,000 miles on the car, can't feel any lips on the discs they look perfect

Afternoon all, So did a fair bit of motorway driving yesterday and noticed and intermittent noise while braking, doesn't happen everytime I brake which makes it harder to understand, more than likely from the front, any ideas, common issues? Discs look fine and pads, could be a warped disc but thinking the noise would be constant 🤔, as ever any helped appreciated

Flashing, fail lights it is them 🤣🤣

Evening all, Apologies in advance if this has been discussed before I did search and couldn't find what I was looking for. So I want to fit a towbar and I'm curious about the electrics/wiring, you can buy a trailer control module for this but I don't want to pay £150 for the privilege, I had the idea of making an inline twin plug loom so it will be plug and play, but is there a reason this isn't done factory? Will it cause canbus errors 🤔, any info greatly received

Lol was a 2017 deffo mqb

I had an S3 brand new that never had it either assuming these are the MQB platform 🤔

Never had the issue until now 🤷