rlp

if it's not a bulb it will be a wiper blade for the mot.

I have had my 1.6 fsi auto 08 for 4 years and I love it. can't fault anything. had no problems except 4 wheel tracking which has no bearing on the engine type or size. power is good and the kick down brilliant.

I used a small set of pullers to release mine with a coin between the nozzle and the end of the pullers to protect the nozzle , worked well but you need tree hands.

Thanks for the help, took it out today, don't think it has ever been out before because of the amount of debris that fell on the floor, as warned by Mikey. the filter was so blocked that I was surprised that any air got through. would advise anybody that hasn't cleaned the filter to do so as it must help the system.

Hi , as title sujests where is the pollen filter, how easy is it to change. not doing my chest any good.

I used 90mm on the front and back of my hatchback, they were fine. due to the curve of the badge i used a hair dryer to remove a crease which they recommend and worked well.

​think you will find all you want on line at keephimatbay . I bought new bonnet , boot and wheel centres , very pleased and not expensive .

where is the tyre wear and are you front wheels aligned correctly.

that sounds much better, thanks brad - where is the best place to start levering. and i dont mean in Australia

Thanks for the advice, will try tomorrow if the weather holds. sounds like a bitch of a job.

hi all havn't been on here for a while but need some help, another rear wiper motor packed in - the question is how do i remove the lining to get to the motor.

hi all havn't been on here for a while but need some help, another rear wiper motor packed in - the question is how do i remove the lining to get to the motor.

happened to me after replacing the handle i alwayys place my thumb on the side and pull in a rotating direction , hasn't happened agian

try pulling away in 2nd

ditto to Tilt

ditto. I had the same problem had it aligned on a Hunter 4 wheel tracker which sorted it out,

Would be interesting to see where the fuel comes from, I don't think any of the super markets have their own refinery's.

fitted a usb to the centre of the three blanks on the dash just above the ash tray. simply removed the blank ,cut a slot to take the male usb and glued the female usb to the back of the blank using a lot of apoxy resin waited for the resin to set then replaced the blank.all that shows is the slot.

Hi , just bought some self adhesive badges from "keephimatbay" on ebay. Various sizes. The wheel centres were very good but the larger one for the bonnet not so successful, air pocket, but I think that might have been the lack of patience on my part. Not expensive and worth a look.

+ 1 indicator stalk left on, I think it alerts you to a parking light on.

Thanks for the warning, how does it compare to normal wheel cleaner and what damage can it cause ? bearing in mind that it is hosed off almost immediately.

Just went to wash my car and realised that I had run out of wheel cleaner, pinched kitchen cleaner. Best I've ever used on my alloys. Astonish kitchen cleaner from Asda £1=00 / bottle, Brilliant.

bought hekko a few weeks ago very pleased, fitted fine - very easy , grey tint look good.

had the same sort of thing happen to me last month. called my brakedown service who said they reset the ECU, no problem since.

sounds like no fuel, would be a good place to start