hussair5

They are definitely going up in value. You can still buy cheap ones but I don't see the point as you always end up spending loads to get them up to a acceptable standard

and that as well please

if you go for cupra cast arms, hubs etc it wouldn't put stress on your drive shaft

sine you are moving on to more track focus car, you don't need the ARM REST LOL - I will have it is that customer intercooler pipework?

Fair enough. Not a bad price. Is it a quick rack though?

how come mate? I have just bought a second hand LCR quick rack for £60

ok mate thanks . let us know asap

yes they must be mate, I have seen them on ebay ? give us your paypal and I will pay now if that's ok

jb21 -bit of an odd one - how much for the drivers side heater air vent please? posted

do these fit Octavia mk1 vrs

audi subframe and Octavia mk1 vrs exactly the same or different?

THANKS mate. I will be ordering ap springs as well along side top mounts. i is it just me or the pictures up to page 14 or so aren't loading up ?

you got any pics of these on standard spiders? it seems to sit lock at the back?

I didn't really cover the holes. I wasn't very detailed to be honest . I wasn't really aware a little bit of a hole will have such big impact . so this time I will put a tape around it

has any one had any luck with this recently? just rang my Skoda dealers and they have stated, no recalls are over due

thanks mate. My membrane wasn't tight at the bottom, the way I sealed it, it was allowing the water to just sit . you have been a great help . Thanks

does the car have bigger tip?

appreciate your reply one again mate. this has been going on for months and I am now losing my patience with it. I have even bought a outer door seal but as you mentioned water is still going to get in any way. so when the water gets in the door, is it suppose to run down the membrane on to the drain holes?

can any one tell me please guys where the drain holes are other the bottom of the door?

rear of the door? The only drain holes I have found are at the bottom of the door?

Are you serious? there is just too much water getting in - what do you suggest because all the drain holes are fine . you putting it down to the membrane then? I have ordered a new door seal any way as it has gone a bit too soft .

20190407_175935_864x486.mp4

hi mate, I have done what you suggested . I poured water from outside . the water is leaking through the door seal as circled in blue in the picture. so take it its new door seal time? I wanted to put a video up on here but I cant unfortunately as it says file size too big

I used butyl strip and definitely no gaps left. yes I accept water is always going to get in the door card but in my case its not draining through. its almost as if the water is getting in from some where and running along the membrane and getting stuck there. I am 99% sure the membrane it self isn't a issue at all.

It could be mate but hard to say really. As you can see in the pics how the water is getting behind in that membrane and sits on the sill.