gizmo98

Still no luck,I’ll just have to live with it I think lol

Good man,I’ll try that later

I’ve since unchecked that,still the same any coding I’ve done is with genuine vcds,unsure if anything was done before

These what you need to see ?

Still can’t get auto lock turned off on my mk2 vrs fl tried in both long coding and adaptions...it still locks ! Using genuine hex V2 vcds any idea ?

Theyre hit and miss,most miss a con rod at 100k

Going well for a BXE,or is it on it’s 5th engine lol

I’ll grab one tomorrow evening

Tryed all settings to turn this off and still doesn’t turn off using genuine vcds Hex V2 many ideas ?

I have 20mm rear and 15mm front 8mm spacers will be no use,you need hubcentric ones

Wee buff and a couple of coats of wax new wheel spacers,wheel centres and mud flaps fitted

I tryed that as well,no luck

Ahh I get it now,I’ll stick with the black screen

A brick ? its just the start screen that’s black ?

Tried to change the start up screen on my Columbus Got the proper discs and Gos through the process and says it’s done but all I get is a black screen ? Using this guide ... http://www2.netdata.be/iso/

Just saw this bit of a short notice for me I’ll do my best to make it and bring my vcds for anyone who needs it but it’s looking doubtful atm

Beach babe

Also check the clutch pulley on the alternator,could be duff

Yeh egr would throw those faults too

H&R 50mm springs,lowers the vrs about 30-35mm

I'd be looking at the wiring then

Was the replacement the same part number ?

Bought this lot recently of anachemni the best cleaning gear I have used by a mile ever the purge is also miles better than iron x and with no nasty smells either

After a wee clean up a few weeks back

Steering wheel and bolero sold