Kcha

1st a special thanks to all of you espesialy to KenONeill RicardoM HeavyMetalRich. I was busy all summer so never had the time to reply (thats not good i understand) So anyway my apologies I fixed the leak at carglass company, They said its nothing serius so they put a black silicone for sealing around the windscreen Now everything is ok Kind regards

Dear all i made a problem and i dont feel comfortable . I am here to take advices, never criticize none, sure never none doctor gives diagnosis by phone or internet I m only asking opinions and as already said to Ricardo i have respect to the members who spend their time and knowledge for me . Sure there is a misunderstunding on my words Just for info next days i ll go to open the windscreen . It is tirιng to apologise for something that i never mean. Have a Goog day

Also my apologies to Ken and Ricardo for the misunderstood

My friend pinjon, i m sorry if there is a misunderstood on what I said. I did not said that the advices are not correct contrarily i m here to take advice and to give what happend to me. Sorry for the misunderstood. I ll give the news and photos when i ll solve it . Have a nice day my friend and thanks for the interest

Goodmornig friends today i went to an electrician cause the heater blow was not working yesterday evening Forget to say that yesterday afternoon i check it as Ken said (Next, since he's seen your cat and I haven't he may well be correct, in which case you need to make sure that the plenum under the heater intake isn't holding standing water. It's actually easier to do that by looking into it, and using some soft but thick wire to clean the drains than it is to describe!) I cleaned it cause the 3 holes was complete open and there were some garbage etc . In the morning when a start the engine i tried the heater and works fine! Magician felicia.Probably it was wet fuses. So today the electrician did the same with me (as ken said) he wet it and all the water went down the engine on the road Second : he took off the battery to see if there was any problem (see photo) nothing there too, we wet it with a lot of water nothing hapend. Inside the spong was dry and after a few time still dry. He gives up and made a call to his friend (Sheet-iron merchant Is it correct word?) . We are going to make an appointment to check it to !! Next step try again from the start by windscreen rubber anyway o, hope that i m helping anyone with the same problem.

RicardoM no crack its just a reflection

Dear friends I appreciate your interest. RicardoM i ve already read your posts (respect) earlier but at carglass they told me after the check that is not need to change it , ''dont spend your money'' i was there for this job to change it. I want to check the heater unit now as they told me to do and then i ll see what to do KenONeil i ll try to check the heater by myself now am on youtube try to understand what to do I m not desperate yet. thanks God the rain stops

Hello again the results are The windscreen is ok also the rubber is ok The professinal said that probably the problem is on the filter where is the heater blower . he said that sometimes (common issue) at skoda there stacks water . I don t know what to say. He can t check it he s only car glass prof. ? Well the rain stops and until next service or rain i ll wait

Hello friends We tried to fix the windscreen alone at home but it s difficult for us , (as KenONeil said) the rubber . I do believe that is a dangerus job for a newbie and we could broke the glass. News are coming hope and photos

!!!! Listen ken. When my friend check the rubber he saw something on the metal (at the roof side) and he told me that there was an earlier change of windscreen!! the photo is from the car today Now i do not have lights (Direction indicator lamps) so its a problem until tommorow when i turn. The strange is that while still raining 2 days , today the car is not a pool the problem stops, and i found water (small) at drivers side but probably its from yesterday

KenONeill thanks for the advice , i went before 1 hour to a friend and he check the rubber with water (he was inside the car and ι irrigate water to the rubber ) . So @HeavyMetalRich and KenONeill are correct. Tommorow i ll go for messuring the windscreen and rubber just to change the rubber , is it possible to add any silicone or something else there? 2nd : do you thing that is better to seal the 2 holes or to set them as they are? Thanks you all I ll try to add photos of the job

Dear sir HeavyMetalRich Tomorrowi ll go to garage of my friend We are gonna check the windscreen as you said. Thanks for your kind answear anyway, and also for your time. i want to bielieve that is not something very expensieive . Kind regards I do believe that here i ' m getting infos for my car so i ll turn it back on time when i ll be able

Thanks my friend I checked at the forum and i found here this do you meen to seel the two holes on red? (THE PHOTO IS NOT MINE ITS FROM THE TOPIC common issues by Tech1e) i just notice with red

Hi again ! So yesterday it was a rainy day , when i took the car (felicia pick up 1,9) passengers foot was full of water! The water comes behind the glove box, by hand touch under that i touch wet spong , i dont know what to do any advice is Wellcome. Thanks advance.

National dealer from volkswagen

So yesterday i took the car money: 300 euro nr 10 & 13 from the national dealer in Greece + the job from the mech I think it s a little bit expenc but what can i do , So the car goes silently now and i m happy, hope nothing else bad comes. Thanks all for interest and for the posts

Thank for the advice my friend i ll post the results from tomorrow

My friend hello again. The results after opening: Nr 10 needle bearing OFF (destroyd in small peaces) Nr 13 mounting OFF (not in small peases) After of 3 hours hunting we found them and tommorow i ll know the price Until know nothing more but you never know Thanks for your interesting anyway, it was the first used car and i not gonna do it again.

KenONeil what do you think about the tiny metal filings that i ve seen inside the oil with the magnet ? Kind regards

Dear friend thanks ! Probably you know better than me , so the replacement of the tyres it is going to be after i spend money for the gearbox. also, yes it is 5-speed (felicia 9/1999 1.9 d). On monday i ll speak with mechanic and i m gonna tell him to check first the nut securing the 5th gear cogs if is loose. Is that nut inside the gearbox, or ? i mean is it necessary take it down of the car? Thank s again for your answer. I have the pick up and i do nt use it until monday & more, is not good.

And finally its the end of good luck !! Yesterday a strange noise came down from the engine . Pressing the clutch noise stops and everything is ok. After about 200 km today i came back from farm, so in the morning i went to mech. He drives it and the result is , problem at gearbox bearings! we change the oils (valvoline) he put a magnet were the oil runs out the results= TINY metal FILINGS at the end , when the oil finishing outcoming more of them :( so sad . From Monday he ll start the job. We ll see about the money! but i don t have car now for my new walnut trees to take care them and i have to go there with a c3 Oh i have to say that here in our area we feel so bad about the terror attack at london yesterday. you have our sympathy

So any advice is wellcome, realy . About learning i have these http://www.realoem.me/Skoda/CZ/PICK/2000/97/R/6 http://www.oemepc.com/skoda/parts_lst/markt/CZ/modell/PICK/year/1998/hg/6/catalog/sk/drive_standart/97/lang/e Anyway any advice is welcome and that is very kind of you I m owner of a peugot 307 2002 and a citroen c3 2008, first time diesel engine . My wife became farmer last year so i need a car like pick up . Felicia ir was cheap and not big, so i hope we made the something right. We will see.It is a used car and know i have to learn about it and about agricultural life too but i like both of them. I ll try the best and all of my family they already loved that car. Kind regards my friend

Hello again. So about the whells i asked the dealer about them where they came from but he had no answear, The wheels are also different size from other felicia (semperit 175/70) For the hand brake i must work it some days (there was rusty wire rope) and them it will be Adjust (the mechanic says is too high now) I dont know much about mechanical now am reading (also youtube) so i have to learn.

1st I m going to paint the bedliner with polyuria 2nd i ll try to find a central console , , There are some pics of the car . I already install an audio from my other car .

Thakns for the reading (it mean that someone has try to help) So i went to my mechanic and told me that the first i about mice (to sent thme away) Second the pipe now is out it was not necessary Anyway thanks