Johnny44

Hi! Sometimes I have a problem with my clutch pedal before i start my car's engine. Starting to depress the clutch pedal I feel the pedal becoming more and more stiffer, then I feel and hear a pretty big clack and the pedal continue his way to the floor easy. Next step I start the engine and the clutch pedal is working normal. I have this problem quite rarely when the engine is running. When the engine is off this problem returns frequently. I have no problem with gear shifting, the clutch does not slipping. What could be the problem? Thanks for the answers.

No problem.

Yes, this is normal. My problem is when I unlock the car with remote, and open the passenger door, or any rear door, the alarm does not recognize this. Because i don't know how to connect these doors to alarm unit.

My big question is, where to connect the 'door negative trigger' wire and how to connect all doors to this wire?

Yes, all door locks, microswitches was repaired, remaked the solders.

Left hand drive.

Hi. I have a VW Polo 9n 2003, is similar to Fabia 1, central locking, two electric windows and I installed a remote central locking with alarm. I wired up the lock - unlock wires to CCM, pin 6, the unlock wire with a 220 ohm resistor and works fine. The alarm module has two wires, door trigger negative and door trigger positive. I tied the negative door trigger wire to the Power supply control unit, plug XS4, pin 6 (front left door switch input). When I disarm the car and I do not open any door, the alarm module rearms the car after 30 seconds. If I disarm the car and open the front left door the alarm module notice this and do not rearms the car. I found the other doors switch input in the plug XS4 (pin3 rear right door, pin4 front right door, pin13 rear left door), I tried each pin separately with the negative door trigger wire and it did not work, the alarm module rearmed the car after 30 seconds. I measured the voltage on the pins, pin6 had 7.5 volts, pin3, 4, 13 had 4.5 volts. Where did I go wrong?