gingerrob

can you supply the parts only for a roomster 2012 TSI? I'm in Cornwall and have vcds and have fitted cruise to caddy's and transporters before so just need the bits 😁

Just done an install of exactly the same head unit in my Yeti but for the life of me I cannot get the info dapter to work, any tips on the dip switches etc, steering wheel controls work fine but I cannot get the setup menu up? Been trying so long just killed my battery so have a few hours whilst it charges!

Finally sorted and a new set of tyres balanced and a four wheel alignment has me running smooth again!

The rear nearside tyre does seem more worn on the outside shoulder than the others so maybe try a proper tyre place as Kwik fit did not fill me with confidence when Thu did the balancing....

New wheel bearings fitted. Did think clutch bur it is smooth in operation no judder pulling away???

Have a 2011 Yeti 2.0 110 2wd and since I got it in December it has had an annoying vibration at 60-70mph. Had the wheels balanced - no difference Changed the nearside ball joint and wheel bearing as it seems to be coming from that side. No difference. Changed the discs and pads whilst I was there, no difference. Slight noise when turning right from left hand front area so bit the bullet and changed the driveshaft including both CV joints. No difference and the slight noise when turning is still there???? Dipping the clutch makes it reduce slightly but it is still there. At a loss now any ideas please...