Mcoctyvrs
Finding my way-
Posts
11 -
Joined
-
Last visited
Profile Information
-
Location
Trowbridge
Car Info
-
Model
Octavia vrs blackline
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
Mcoctyvrs's Achievements
-
Are there any members left in the SW now lol
Mcoctyvrs replied to DaveinCamborne's topic in South West
-
Mcoctyvrs started following HarleQuinn
-
Trowbridge, white 62 plate Oct ll vrs blackline
-
I haven't yet come across those threads but when I do I will add them, just trying to put as much info in one place. unless you know where there are to do so. Thanks for your input
-
List of briskoda users with vcds VCDS Owners Map
-
DISCLAIMER:-You follow this at your own risk, I am not responsible for your errors!! OK, so all the Blackline owners out there who want to enable Bluetooth and install the microphone here’s how to do it. Enable the BT using VCDS, here’s the link how to do it:- http://www.remkoweij...uetooth-carkit/ Order the microphone from Carsystems http://www.carsystem...only,id387.html or Eddie-NL:- http://www.briskoda.net/forums/topic/274292-blackline-bluetooth-kit-loom-mic/#entry3244289 Ensure that ignition key is removed Start to remove head unit surround using trim tool. Remove the four T20 screws from the head unit Pull the head unit forward carefully and remove the quadlock using the latch and remove the aerials, there is a clear tag that pulls forward and is pressed down to release the three leads. Remove the passenger side panel using a trim tool (same setup as fuse cover). Remove the five T20 screws from the glove box, remove the aircon pipe and light connector. Remove the A pillar cover using a trim tool, quite easy to pull off. Remove the interior light by removing the lense with a trim tool and remove the two Phillips screws (one either side of the main light bulb). Remove the foam insert and insert the microphone (should not be connected to the loom at this point). The mic is keyed. Insert the green connector until the barb secures it. Run the loom (up to you how you do this) behind the glove box and up the A pillar (lots of option how to do this). You need to get the connector all the way to the hole where the interior light was (the loom can be easily squeezed into the roof ling and out the hole). Connect the loom and mic together and clip the connector into place (I used a bit of the fabric cloth tape I took off the loom to insulate the connector as a bit of screening was exposed) Refit everything back in reverse and there you go one BT mic installation.
-
Spoke to eddienl to get a loom made as couldn't find one other than the Chinese ones. Mic 3B0 035 711B from factory retrofits. Any one local that has vcds can activate bluetooth function or you can use obdeleven to do it yourself if you have it
-
Hi sorry to bring up an old topic or thread but was after some help on where to get a blackline bluetooth kit from I've seen some of the cheap Chinese ones but have read that these should be avoided. Has anyone used these and is this the case. I've been able to find the genuine microphone just have issues with the loom. Any help would be greatly appreciated. Thanks
-
Welcome to the community
-
Welcome to the community
-
Welcome to briskoda, I'm new also but the guys on here have a wealth of knowledge and are willing to help with anything