WingedArrowFan

Does the trunk handle on the lid work and does the dome light turn on when you open the drivers side doors? The trunk will not unlock if the microswitch in the driver side lock is broken.

It could be a faulty microswitch in the lock. If you can lock the driver side door with the key the fault is probably not mechanical.

Hi, unfortunately I didn't. I've found some software that can do it but it is way too expensive for just one go.

Yes, It does. When I've trier it today it worked fine so the fault seems to be Intermittent.

I've tried every door but it didn't help.

Hi, I've run into a problem with tailgate after replacing the switch on driver door lock (tells BSG when the door is open). Before the switch replacement the tailgate worked fine (exept for that switch :D) but after I've replaced it the tailgate can only be opend by the lever on the driver side and the remote. The problem is that the handle in the tailgate only works a few seconds after unlocking the car and then the tailgate "lock it selt". Any ideas?

They don't know either on Ross-tech because they only do VCDS.

I've been searching for the answer on the internet for over a month and still nothing. I'm pretty sure that it is posible i just don't know what software it requires. Does anybody know?

I need that cluster pin to login in to the immobiliser right?

I have Vagcom but that will not read the pin or let me rewrite the eeprom memory. The new cluster is in mph and i need to change that to kph (imported part - a lot cheaper), i'm puting mk2 cluster into mk1 car so i need to change some variable in the eeprom to make the fuel gauge work properly. I've been reading on this "mod" and apparently i also need that pin (Vagcom can't read pin).

Well, yes. I neet to known what do I need to do things like read pin, change eeprom settings and to adjust the odometer.

Does anybody know?

I've read somewhere that Vag Commander 3.6 can do it but i'm not sure about it.

i'm not sure. Its the pre-facelift one with white maxidot: 5J0 920 841B.

Nobody knows?

I'm replacing my old cluster with a new one so i need to read the pin and adjust the odometer.

Hi, what do I need to find out a pin and rewrite eeprom memory on mk II cluster? I use Vag Tacho on mk I but that doesn't work on mk II.