littlejimmy
New here-
Posts
5 -
Joined
-
Last visited
littlejimmy's Achievements
-
littlejimmy started following EGR Valve / fuel rail issues
-
Hi, my 2014 diesel fabia estate died this morning whilst driving, no indications, just cut out. I had to get the AA out to get it started and they said it is likely the EGR valve. I had my local garage run a diagnostic report and it gave 2 faults 1) P00C600 fuel rail pressure too low - Engine cranking and 2) P040200 Exhaust Gas Recirc.Flow , excessive detected. Can anyone advise if this is this a common EGR fault, and is it covered by any recall before I go spending around £900 for a replacement? Thanks James
-
Thanks for the ideas. I'll have a look at what's been suggested. Will any reversing sensors and reversing camera connect or do you need special connections?
-
I have a 14 plate mk2 fabia SE TDI CR 90 estate. I am looking at changing the stock radio for something that has sat nav and bluetooth so I can use my mobile when driving. Also I am hoping to add reversing sensors and a reversing camera, is there a unit which will allow this? Would I need to go with a genuine Skoda item or are aftermarket ones ok? Is it best to buy a a unit which comes with reversing sensors and a camera or can they be connected later? Any suggestions of what and where to buy would be really appreciated Thanks in advance for your help
-
Still trying to find out what people think is the best upgrade to the stock radio.
-
Hi everyone, I have a mk2 fabia estate which I have owned for a little over a year. Not sure what the trim level is but its nothing fancy, just a plain 1.6 diesel. I was looking at upgrading the stock radio to something that includes a sat nav, hands free option for mobile use, and could also accommodate reversing camera and sensors (which I want to fit also). I don't really care about watching dvd's or listening to the radio to be honest, just the satnav mobile and camera options. I'm not sure if I should go for a genuine skoda unit from a newer model or if an aftermarket solution is best. Is it something that can be done diy or do I need to get the coding changed as well? Any suggestions/advice would be appreciated. Thanks