Stuart1234

Thank you wino and Langers both have helped with repair information . For anyone reading this post in future wire break in cable Loom to abs unit, rubbed against abs unit. Mine had pin 1 red wire to fuse 4 cut through however could of happened to any cables in Loom depending on routing. Checked all circuits with continuity and 60 ohms can bus. All fixed and tested good.

Thank you Langers great help

Fantastic Wino, could you help with one other question I am used to saab connectors pry red tab and to get to terminals slide plastic. Have worked out how to remove delphi connector with clamp arm release then pull tab up similar to saab connector. However how do you open this up to get to terminal pins

Thank you wino really appreciated

Hi all I have an octavia 1.9tdi 2007 with error P0600 with brake light, ems, power steering lit, speedo not working an fuel gauge flipping up and down. I understand communication error and read a few posts that suggested abs unit replacement. Today decided to get to unit to check wiring on removal of plug found harness rubbed and red power cable chafed so my likely fault. Does anybody have pin designation of the delphi 26 pin plug so I can check can bus, other grounds and positives? Kind regards Stuart