RedFoxFinn

We did screw new, better screws with the power drill while attaching the bar mount/plate frame. We measured the center point and marked places for couple screws. Attached loosely first and after screwing in half of the screws we tightened them. Plate needed new screws anyway because they were almost completely rotten.

Later last night we decided to complete the installation and we were successful. Pics for proof Wire for light goes under the left headlight assembly and behind the top part of mask to right side and from there to the light through the lower grille. Attaching the ground of lights wiring harness was pain in the butt, simply minimal to none space available for tools.

That would be amusing... Our laws and regulations state that I cannot connect that DRL if I don't disconnect built in ones first. So, that'll remain for later use (maybe).

Pics! From Finland also and exactly the same problem. I tried to find correct wire for an hour but couldn't find right connection visible enough to measure. But now I have it and tomorrow we'll have more light! Our lights are Strands Siberia 22" SR and they are going to be quick mounted with M8 quick release clamps. While in city we won't have them mounted and leaving city we'll mount them by just clamping and attaching their plug.