Lee28

Same issue here Asv rubbish

You can mix the Castrol products you mentioned. If you check the bottle there is a Tech Helpline number. Have posed a similar question to them in the past. Got a call back from the department ............... Very informative service

I`m looking for an offside hub with good wheel bearing if yours is the same as 110 Tdi 2001 I`d have it thanks

Apologies ............. My appointment to Vision Express is overdue. Okay I may need to raid a piggy bank or two then

Good luck with the sale and thanks for not replying to the questions.

Hi, Can you let me know what this is like on fuel. Would you be interested in a swap ? Thanks

This could be the auxiliary belt tension er. I had a similar issue. It was more pronounced when engine cold. It was replaced after a period of time mainly due to annoyance of the noise.

I have a G60 flywheel spare if interested

Not in Ireland unfortunately. Just realized your location

I have a G60 flywheel going spare if you are interested

Hello, Is that a Sachs flywheel?

May be interested at £12 delivered? I paid eleven delivered for my Briskoda surrounds... cheers

Hi, I lost my key temporarily recently so now debating on owning a spare flip type or not as it would be emergency use only. How much please?

Did you get a G60 flywheel ? I have a one spare Thanks, Lee

I`m interested in the tyres thanks

Its not listed now

Hi, I have a G60 Flywheel to use as a conversion to single mass clutch setup. My dilemma is that none of the parts places such as Tps/ Europarts etc seem to know which 3 part kit will match up with it. Ie pressure plate/ release bearing and driven plate. Ive searched the forums without luck for the info. Could anyone technical please advise me? Thanks in advance, Lee

Chris Routh in parts department always on the ball and helpful. I always use Silbury for important genuine parts. Eg, CTS ... Surprisingly reasonable on some part prices and oil at £25.

You don`t need deep pockets if your an insomniac. Travel for 21 pounds each way midnight to 3 am with wightlink. Ramp isnt too steep either.

Try Cats2u.co.uk Best prices I have seen and quality products/service

How much now? Thanks

This happened to mine resulting in an AA recovery. Take the pedal off ( 10 minute job ) get the small box section which holds ( held before it split ) the plastic bit fully seam welded at a light engineering shop. This will be far superior in strength than the original spot welded rubbish. The replacement is the reversal of removal with added difficulty of having to work on your back and upside down. Its doable if you have patience. Hope you get it sorted. Mine cost me £10 for the weld and has been fine since ( 5 years )

Sullying your thread // what a shame for you... Glad to hear you found someone daft enough to pay your exorbitent price.......lighten up !! You will find lots of helpful `people` on here.. Oh and my head does not need any boiling thanks. ciao

Hi, just to let you know its £29.99 in Blockbuster......................... ooh that penny makes all the difference

Thanks for the info Chris