greetham

fair enough, ill have to get it back on the ramp when i have a bit more time. Did you use one of the universal ones?

I did check this, gave it a good pull/push etc seemed ok? i would of thought it would be covered in soot if it was failing.?

Hi all, So i'm on my 2nd scout now PFL 10 plate with a BMM 2.0tdi, i have had this one a few months now and have gradually noticed the exhaust smell both in the car and out. While stationary its getting strong within a minute or so. externally stood at the back of the car in the boot or whatever its strong enough to make you cough! I have just given it a full service including replacement cabin filter, cars runs great. Had a look on the ramp for any black soot on heat shields etc, all looks ok, im assuming maybe a joint on the dpf or egr? Any pointers or previous experience appreciated, thanks.

Yes all sorted see above post

Motors functioned fine, no worn plastic gears, everything cycled as it should. No issues with coolant flow. No issues with engine temp. No issues with external temp.

All sorted. Checked all motors, all seemed ok. Faulty climate panel in the end.

Cant see it being either of those to be honest, i would get no heat at all surely. When engine up to temp and i set to HI its blazing, everything else cool, i suspect its going to be Temp control flap or motor.

Yeh happy with those, comparing to my other car it seems good.

I understand that. Issue i am having is if i set to 29.5 it is blowing cold. And its not always done that.

Any more info you can provide for this? Ran VCDS last night with no faults.

Morning all, 1st time poster so go steady I have had a search through using various different things, most posts seem to cover fan speeds but my problem isnt that. Heat only comes through when temperature is set to HI, all other temp settings are pretty cool. I have done the flap reset a few times, removed the climate unit and give all connectors a clean and check. outside temp reads ok. i have yet to plug it in to VCDS. Any pointers? Thanks