sukhbira

Thank You scott, i get error when i use handbrake in parking mode. the ABS lights appears on display. and when i switch off the ignition and turn it again, everything goes good. maybe i have a ABS sensor problem also

Hi everyone, I recently bought a VCDS device to explore diagnostics and tweaks on my 2010 Skoda Yeti 1.2 TSI. However, as a beginner, I’ve messed up quite a few settings and now have several error codes that I can’t seem to fix. I was wondering if anyone here in the Yeti community has experience with these kinds of issues and could offer advice on how to correct them? I’d really appreciate any guidance, whether it’s troubleshooting steps or resetting certain modules. Thanks in advance for any help! VIN: TMBJF75L4B6011811 Mileage: 196190km-121906miles 01-Engine -- Status: OK 0000 02-Auto Trans -- Status: OK 0000 03-ABS Brakes -- Status: Not registered 0011 04-Steering Angle -- Status: Not registered 0001 09-Cent. Elect. -- Status: Malfunction 0010 19-CAN Gateway -- Status: Malfunction 0010 4F-Centr. Electr. II -- Status: Malfunction 0010 52-Door Elect, Pass. -- Status: Not registered 0001 56-Radio -- Status: Not registered 0001 72-Door, Rear Right -- Status: Not registered 0001 77-Telephone -- Status: Not registered 0011 ------------------------------------------------------------------------------- 1) 02988 - Left-Hand/Right-Hand Traffic Switchover Active 000 - - Freeze Frame: Fault Status: 01100000 Fault Priority: 6 Fault Frequency: 1 Reset counter: 219 01314 - Engine Control Module 013 - Check DTC Memory - Intermittent Freeze Frame: Fault Status: 00101101 Fault Priority: 2 Fault Frequency: 3 Reset counter: 254 Mileage: 196111 km Time Indication: 0 Date: 2025.05.02. 03095 - Diagnostic interface for databus (J533) implausible messa.: 000 - - Freeze Frame: Fault Status: 01100000 Fault Priority: 6 Fault Frequency: 1 Reset counter: 210 Mileage: 196050 km Time Indication: 0 Date: 2025.05.02. Time: 11:46:17 3) 01317 - Control Module in Instrument Cluster (J285) 000 - - Freeze Frame: Fault Status: 01100000 3 Faults Found: 02395 - Parking Light Front Right (M3) ( am using osram parking bulbs) 010 - Open or Short to Plus Freeze Frame: Fault Status: 01101010 Fault Priority: 2 01495 - Bulb for High-Beams; Left (M30) 010 - Open or Short to Plus already tried to reposition learning coding in basing setting , but no gain 01499 - Bulb for High-Beams; Right (M32) 010 - Open or Short to Plus 01495 - Bulb for High-Beams; Left (M30) 010 - Open or Short to Plus am new in here,. if i post anything wrong or in wrong place please guide me. thank you full scan.pdf