jt1196

Hi all, Am in the middle of fitting a Yeti PQ MFSW to my pre-facelift octavia - so far I've swapped the steering control module for a highline version that supports mfsw and have coded it in so no steering wheel light etc. I've coded the wheel too and the buttons light up but that's all I'm getting - no button inputs and no horn! Faults show a 01426 No signal/communication and having compared my old and new airbag wiring loom, there's one pin on number 11 in the connector block that's missing for the new loom. Am I being too naive to think this just needs connecting back for the circuit to complete for the new mfsw to start working properly? Any and all help/advice appreciated! Cheers

Hi all, Was looking to retrofit the above and thought it were a case of running a repair wire from the switch loom to the bcm (have all the sensors etc it's the one wire that needs adding) but didn't realise the pre-facelift is different to the facelift in terms of where it needs to go! What do I need to be looking for location wise to get this wire added in to? (if it can be added in this way). Cheers!