stathap

1. Remove grill from car using standard hex bit x8 2. Place your shiny grill on a work bench and re-consider what you are about to do... a cup of tea helps here. 3. Drill out 6 no. rivets as shown 4. Using a flathead screw driver, some firm pressure and love.... push out the silver coloured tabs which remove the entire chrome part of the grill 5. Here's the grill in two parts 6. Here's the badge off 7. And here it is in it's first two coats of primer 8. Finished

1. Remove grill from car using standard hex bit x8 2. Place your shiny grill on a work bench and re-consider what you are about to do... a cup of tea helps here. 3. Drill out 6 no. rivets as shown 4. Using a flathead screw driver, some firm pressure and love.... push out the silver coloured tabs which remove the entire chrome part of the grill 5. Here's the grill in two parts 6. Here's the badge off 7. And here it is in it's first two coats of primer 8. Finished

The pics ALMOST do it justice... see it in the flesh and it's :jawbig: lovely car, really well done with a lot of love

ta

I like those a lot (and the new 'tavia in black ), quality are they heavy ?

trap door... ants... cookie... jet set willie... school daze... attic attack...

they're on spaces... American's like a bit of "poke" on the wheels and stretch on the tyres ooh my local bbs dealer is only 15 miles down the road... whoops apocalypse

quiet... sssshhh :shhh: ... now I have to cut up the credit card, hide the wallet and burn my savings book

http://www.spectaculator.com/

Sorry... I was trying to qualify a tender whilst writing that post at the same time = slow :rotz:

And everyone knows that the dream wheel to have is the Le Mans ...ooh and it's the lottery tonight .

Have you looked on the BBS direct website ? http://www.bbsdirect.co.uk/

I rattled it round quite a bit and realised that the mount was completely missing It's getting worse if anything :(

The Jabba one is made by ProAlloy

I think Jabba and Star do Eibach stuff

I must be bored ... here's a blurry pic of mine

No, it dials out some of the understeer, highly recommended. p.s Des, from what EddyH has said then the add on rear ARBs don't fit 4x4s AIR. He could only get a front R32 one on. HTH a bit.

This is a golf but it's the same. Just slide your fingers under and pull it gently upwards.

Good to hear Andre And nice to hear from you too

Good colour and welcome :wavey:

The mount area in question looks a bit like this (taken from a Golf) attached. Anyone got any ideas ?

The only time that something similiar to this happened to mine was after I fitted the TIP... I'd managed to knock lose a wire down there which then rubbed on the driveshaft. It stripped the insulation on the wire and shorted the circuit. A bit of insulating tape and a new fuse later all was well... I hope yours is something as simple . Fingers crossed.

I should add that on seeing the problem it isn't worrying but hearing it sounds like the gearbox is about to fall out. Not good :rotz: