rosco.vrs

Mines exactly the same. Im replacing the turbo tomorrow due to the seals going on it.

Yeh I read your post properly after lol. Sorry mate I had to throw it coz it bent when I took it off the old badge.

You get them from superskoda. I bought one a while back but got rid as they stick on over the original badge but don't sit right.

2 1/2 is best

I tried it on the t piece I already had on the fpr pipe for my boost gauge.

I've just done this and now Im getting a lot of turbo flutter(not good). Any ideas why?

Yes those are the right ones buddy.

http://pages.ebay.com/link/?nav=item.view&id=160983906324 This is what u need

http://pages.ebay.com/link/?nav=item.view&id=141130947794

Mines the same Lloyd. Plus my fronts do it as well! So each corner is different on mine. I'll b watching this 2 see if any1 has some good advice.

Mine didn't fit and iv got that exact one. was it the lower cover which goes around the dipstick which didn't line up so you couldn't fit the top engine cover? If so I just filed it down around the breather pipe with a rounded file until it lined up ok.

I have special powers! Lol

http://pages.ebay.com/link/?nav=item.view&id=321186857941

It just pops out. Dont use anything too hard else you might damage the paint.

Im sure they are 3" at the top end but go down to 2.5" so should fit straight on. Could b wrong.