spoil_kid123

Thanks guys for your prompt input. I have checked for cracked solder joints and did find some. I did not check for any damaged copper tracks. Will do over the weekend. I forgot to mention that my clock and fuel dash lights are not working. Please bare with me on this. Cheers

I know that Ricardo spent a lot of time on this already much appreciation, but I still need help. This is a short clip of how the fuel gauge works. The tank is almost full. The needle goes up to full then goes down to almost half. When it's almost empty it stay on the mark for a few seconds the goes up to quarter. Fuel guage.mp4

Thanks very much.

One more. I still could not get my fuel guage working. Can you indentify what section is the fuel circuit. Cheers

This guy is really helpfull thanks a lot. My tach only reads when it reaches 4000 rpm. Any suggestions.

I own a 1.3 Carb Felicia and I think it still has the original ignition coil. If I need to replace can I put a MSD coil. Cheers

HELLO EVERYONE i NEED SOME HELP WITH MY REAR SUSPENSION BUSHINGS FOR MY SKODA FELICIA 1995 HERE IN THE CARIBBEAN PARTS ARE DIFFICULT TO GET SO ALL WE DO IS SUBSTITUTE. i TOOK ME APPOX 2 YEARS TO GET A CHAIN AND SPOCKET. CAN SOMEONE GIVE ME THE DIMENSIONS FOR THE REAR SUSPENSION BUSHINGS. THANKS.

I tried what you surgested last but no luck. I would like to connect a temporary fuel gauge somewhere on the dash board I have a spare three wire gauge from a 1988 Fiat Fiorino. What wires do I use of the dash.

thanks for the reply. How difficult is it to connect an external gauge.

Update I checked through the circuit and did find some cold solder. But after repairing and installing the instrument cluster back into the car turned on the ignition the fuel gauge went all the way to full. It stays in full wheather I disconnect the wires from the tank or not. Please help

Thank You very much for spending your valuable time to explain in detail. Will work on this over the weekend and get back to you. Thanks very very much.

RicardoM. I checked the wiring on the fuel sender all is good. What I cannot understand is when all the wires on the fuel sender is disconnected why am I still getting a reading on the fuel guage on the dash. Can you explain.

Thanks for the quick detailed reply. Will check over the weekend.

Need some advise. My fuel guage is not working properly. When I fill up it reads about 1/2 and as the fuel gets lower the guage reads 3/4 after using the car for some time it will come down to 1/4 so I fill up again not to take any changes. I checked the fuel sending unit all seems well. But when I disconnected all the wires from the sending unit and turn on the ignition the guage reads just above 1/2. Are you supposed to get a reading if the wires are all disconnected from the sending unit. please help.

No much Felicias are here. Most owners have already changed there engines. However mine is still original and hope to keep it that way.

Hello everyone, I am from the Caribbean. I live on a twin island Trinidad and Tobago. I own a 1997 Skoda Felicia TMBEEA414S0069928 I have never had any major repairs just routine maintenance. I am thinking about replacing the carb with a weber. Engine works fine. No power steering and AC. It is very difficult to get parts. I've been waiting for a water pump from the dealers for six months.

Do you have a better scan of the Felicia Gearbox repair procedure.

What rear disc brake set up did you use. Is it just bolt on.

Hello, I am from a twin island in the Caribbean Trinidad and Tobago. I own a 1995 Skoda Felicia with a 1.3 carb engine and 5fwd manual transmission. My gearbox recently started making some funny noise. I think the bearings may need changing. In my country part are pretty expensive for these cars. If there are anyone who knows about substitute parts for the suspension I would really appreciate the info. I hope to enjoy this forum