Skip to content

Fitting a 1.4 8V MPI (78mm) crankshaft into a Favorit 1.3 block?

Featured Replies

Hi everyone,

Can I fit the 78 mm stroke crankshaft from a 1.4 8V MPI (Fabia/Felicia) into a Skoda Favorit 1.3 block?

If it is possible, how straightforward is the swap and what are the main things I need to watch out for (block clearance, conrods/pistons, flywheel/clutch fitment, etc.)?

Thanks in advance!

It's not straightforward at all, Fabia block had been modified quite substantialy to fit the larger crankshaft. From my memory, a centimeter or so has to be taken off the counterweights to fit into 1.3 block, the axial bearing is on a different main bearing, the timing chain sprocket is different and flywheel has 6 holes instead of 4.

  • Author
22 hours ago, Papez said:

Hiç de basit değil, Fabia bloğu daha büyük krank miline uyacak şekilde oldukça önemli ölçüde modifiye edilmişti. Hatırladığım kadarıyla, 1.3 bloğa sığması için karşı ağırlıklardan yaklaşık bir santimetre alınması gerekiyordu, eksenel yatak farklı bir ana yatakta, zamanlama zinciri dişlisi farklı ve volan 4 yerine 6 delikliydi.

Thanks for the warning!

By the way, does the 1.4 MPI Fabia block bolt directly up to the stock Skoda Favorit gearbox? Are there any clutch, bellhousing, or starter motor alignment issues when using the Fabia block, or does it require modifications on the clutch side?

On 13/11/2026 at 12:16, Mahmudd said:

By the way, does the 1.4 MPI Fabia block bolt directly up to the stock Skoda Favorit gearbox? Are there any clutch, bellhousing, or starter motor alignment issues when using the Fabia block, or does it require modifications on the clutch side?

The block itself should fit.

Flywheel - this article mentions that you can use the Fabia flywheel in Estelle with a 5.5mm spacer, so it should fit Favorit, too. However, it mentions that to use Estelle's starter ring, the flywheel needs to be ground to a smaller diameter. I'm not sure if the starter ring itself is the same as Felicia or not.

skoda-virt.cz/cz/clanky/motor/7994-par-tipu-na-upravu-motoru-1-4-mpi-do-742-3/

There was user on Briskoda, who fitted Fabia engine to Felicia, but they swapped flywheel, too.

You'll also need to figure out engine mount, on the pump, as Fabia has different pump and V-belt closer to the block. It also lacks output for the distributor, but according to the article above, you cannot just swap the timing chain cover, because it contains oil pump, and the older oil pump is not sufficient to pressurise Fabia's hydraulic tappets.

In any case, the rebuild will always require some form of mixing the parts of the 1.3 and 1.4 engine.

Edited by Papez

Create an account or sign in to comment

Recently Browsing 1

Account

Navigation

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.