Jump to content

Brygill

Finding my way
  • Posts

    22
  • Joined

  • Last visited

Profile Information

  • Location
    West mids

Car Info

  • Model
    Skoda felicia fun

Brygill's Achievements

Apprentice

Apprentice (3/17)

  • First Post
  • Collaborator
  • Reacting Well
  • Conversation Starter
  • Week One Done

Recent Badges

3

Reputation

  1. i havent got any way of checking voltage apparently some parts where changed over becuase they didnt look to good. At the moment this is not as important as on my way home in it tonight the temp just touched red so turned engine of and rolled to the inlaws. Coolant had all gone even though topped up the day before but near the thermostat housing there was steam appearing can not say directly where it was coming but when i put in new fluid it was wet under the thermostat housing and the bottom right corner of the engine checked all pipes and no splits. all pipes were in great condition could one of slipped a little.do i buy a new thermostat housing just wonder how would you guys go about it where to start if a pipe has slipped best way to check anything to put on pipes and look for it bubbling
  2. It had stalling problems before the engine swap engine was swapped because was letting out blue smoke. Did have throttle body clean and reset but no different all parts that were on pickup before are the same leads. In did notice that thermostat was not working properly blowing Luke warm so I swapped just the thermostat over to which I now have hot air coming out temp gauge goes just over half way. I did notice that the temp sensor on pickup had a blue ring of plastic while the one on the other engine had a yellow if that makes sense. Without the heaters on it revs fine no eratic idle untill they are turned on full
  3. Have finally changed the engine in my Felicia fun but stalls when cold when warmed up runs fine well about 800/900 rpm but when the heater is turned on wether cold or hot air the revs go mad up and down between 200-900 rpm any idea what it could be
  4. Would of measured but completely rotted and snapped of never to be seen again
  5. After the back box fell of my felicia fun I decided to swap it with my doner cars exhaust while doing this I noticed that the silencer had seen better days so was going to replace both. After several sprays of wd a lot of banging with rubber mallet wiggling and slice to finger exhausts were of. Then the trouble started I fit the silencer with abit of persuading with the mallet and it didn't seem to line up with the existing brackets about an inch out needs to go towards the front of van. Thought will be ok just stick out back a little more but when fitting the back box it seems that the whole exaust needs to come towards back of the van as back box is protruding passenger side rear springs. Completly confused as why would it be a different exaust was of a skoda felicia 1.6 Glxi can I just put an extension piece on if so will it affect mot
  6. Hello all well have nearly completely stripped my Felicia 1.6 Glxi only took several months but can now see the light. not very mechanical minded all parts will be spares for my fun only thing that is left it engine and gearbox not a clue where to start with these I do have an engine hoist available at the ready. Where do I start would it be easier to take engine then gearbox or vice versa and where would I start I no gearbox needs be jacked up and speedo cable removed any things I need to look out for as box will be fitted into my fun (not by me thank god) any help guides will be much appreciated
  7. Hello have had a go at fixing my rear seats so that they lock into place I've had the catch of and removed all the very badly damaged plastic from catches (a temporary measure I no) but now the when I try to put the locking machanism on something has slipped inside is it just the four fixings in the centre of the seats to get to the machanisms inside
  8. Where about are you bud never no I might be heading your way for work or something in near future. Also I will have that rubber of you how do you want me to pay for it thank you
  9. Bry bricklayer Worcester akoda felicia fun 1.6 Also villa fan vtid
  10. Ye if you could how much do you want for it and postage thank you
  11. I'm looking for fellow briskodasnwho know there felicia's around the Worcestershire area I've got a felicia fun that has several niggly problems that need sorting my mechanic has let me down that much saying he will do it this day so day of work take felly down on morning for him to say I'm to busy today bring it tomorrow lost about 2 weeks pay in month now and can't keep doing this will
  12. I can't find anywhere breaking any near me and places will not ship because of it not being worth it to them have up loaded parts picture if any body has number 9 please let me know thank you all
  13. No there isn't any rubber on it just straight to plastic pipe that was taped up really bad
×
×
  • Create New...

Important Information

Welcome to BRISKODA. Please note the following important links Terms of Use. We have a comprehensive Privacy Policy. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.