dave0885

theres a C type clip that you pull out that holds the sensor in, pull the clip out then the sensor can be removed

Thanks Vindaloo i will check the electrical sensors on the engine

hello all,,, my skoda fabia vibrates when i rev it and also when im driving, but goes when i ease of the gas, i have chenged the engine mounts, front crank pulley, flywheel and presure plate and clutch plate, and it still does it, I would appreciate any help at all before it costs me any more expense

Hi all, I have a Fabia 1.9 TDi 2004. It has a anoying vibration at idle and when driving, it feel like the engine mount have gone and its vibrating throught the car, skoda told me that it could be the DMF and advised me to put a solid flywheel on, so i bought a new solit flywheel with presure plat and clutch, and it is still the same, so i renewed all the mounts which didnt cure it, I then renewed the front crankshaft pulley, could anyone give me any pointers on what it could be

I done my ball joints 0n my fabia1 1.9 TDI, all went well until i turned the steering and the calipers were hitting the bottom arm, there are 3 types of pin on thees balljoints mine is a 15.8 mm, and the ones i bought was 15mm, not much i know but makes a big difference

I have a Skoda Fabia 1.9tdi ATD engine, will the later 6 speed gearbox fit my car, as the gearbox is noisy and needs replacing

yes i did and it was 69mm but all the new ones have a steel outer which wont fit, the original was plastic outer but cant seem to get them anywhere

Hi All Can anybody tell me what diameter the rear trail arm bushes are, i have tried two sizes first ones were 72mm and second was 69 mm and neither fit , the new ones have a metal outer and the ones i took out ( which i had to put back in ) had a plastic outer, im just confused which ones fit my Fabia 1 1.9tdi 54reg 6y2

yes i used waterproof tape on the original holes, or you could seal them with the silicon sealer

Hi All I have a 54 plate Fabia 19TDI. been a great car and read many good things about them. but a lot is said about the leaking seals, i cured mine overnight and never had a problem since. I took the panel off and took of the window carrier, mine was riveted on, cleaned all the old seal off and put a nice thick bead of silicon sealer in place of it and left it overnight to set. Next morning i put the carrier back on the door using a couple of the original holes just to line it up, i just put nail punches in to hold it, I then drilled smaller holes next to the original big rivet holes and used self tappers all round, its been 18 months now since i did it and its never leaked in