wilson-uk-85

I have just replaced the front passenger side dipped beam headlight bulb on my Fabia MK3 and what a carry on. The access is so tight and limited both down the side of the battery and the under wheel arch access panel with removable cover. I eventually got the old bulb out and new one reinserted but trying to reinstall the the bulb holder into the light cluster was just as fiddly. In the end I had to disconnect the battery and remove it just to finally refit the bulb correctly. I have replaced plenty bulbs on previous vehicles I've owned in a matter of minutes. The last time I had a headlight bulb out, I went to the Skoda dealer who actually replaced it in like 20 minutes not like the 2+ hours it took me. Is their some kind of special tool which clamps and twists the bulb holder which they use. I've had a rear tail bulb and side capsule bulb out but it's just 2 torx screws and a wiggle of the light cluster to unclip it, they were quick and easy to replace. In future the garage can do the dipped bulbs. I found once was enough doing it myself. I got their in the end and now both headlights are working again, sighs!

greetings fellow Fabia MK3 owners... I have thought about giving my Fabia a bit of an interior makeover, I would like to replace all the interior lighting with LED bulbs, the front interior light both centre and left/right map lights, the glovebox light, rear passenger lights above the doors and the boot light. I don't want to use any old cheap bulb but a decent reputable brand, also would there be any canbus issues?

@DGW How has your Fabia Mk3 been with this Yuasa battery, has everything functioned as normal after installation and coding, no warning lights, stop/start working as normal etc. ?

I now have a Carista Evo dongle (great little obd2 device). I've accessed the BMS and the information currently held for the Exide 59ah EFB battery is as follows: Battery capacity: 59ah Battery technology: EFB Battery manufacturer: JCB Serial Number: 1111111111 The new Yuasa battery is 65ah and Carista can set that, the technology is EFB so that'll be left unchanged, what do you enter as the 3 digit vendor code as this is an aftermarket battery and what about the serial number. The Yuasa has a serial number which begins YI with 9 numbers so is 11 digits not 10?

Hi, I have a new Yuasa YBX7027 battery for my 2017/67 Skoda Fabia. It's surprisingly still on the original Exide EFB 59AH battery but it's starting to get less efficient. My car as usual has the battery management system (BMS) with stop/start and my vehicle requires a new battery to be registered with a diagnostic tool. I've been looking at videos and things online and Carista seems to recommended. Has anyone else with a Skoda vehicle of my generation or another VAG car such as a VW, Audi or Seat fitted and coded a Yuasa battery? using Carista? This battery is a 65ah EFB stop/start type and it's serial number starts with "YI" followed by some numbers.

My Skoda Fabia has just had its service & MOT. I have a folder with all the service history in and I have looked up the wiring loom that failed. VW part number 6C0 971 349 PC. It was the battery connections to the alternator.

My 2017 Fabia is still on the original Exide branded battery from the time it was manufactured and is functioning ok. The issue started intermittently but they couldn't diagnose the issue until the wiring loom finally failed. The battery from time to time wasn't receiving the 13.4-14.8v charging current. I recommend booking in with Skoda or a VW group specialist, or a garage well familiar with the Brand especially if they have the official VCDS equipment.

As long as there isn't any noticeable cracks to any of the wiring looms insulation you should be ok. The damage for me meant the battery also wasn't getting a stable charge from the alternator, was charging as low as 9-11v rather then 13.5 and 14.8v peak.

It was a main wiring loom connecting the ignition switch, alternator, battery and starter motor. Power was not getting from the battery to the allow the car to start "just a relay click" and even with a jump pack no luck. The breakdown agent as car was stuck on my drive got it started by applying a jump pack directly to the starter and it fired up and drove to the garage no problem, once parked at the garage, he said try restart it and it didn't, "just clicked". The garage replaced the loom once technician diagnosed the fault and it there has been no further problems. There was load of oil they had to clean up.

I've responded 😉 I've responded 😉

I'm sorry to see this has happen to you also, this happened to my Fabia last year and was fixed but a month later It suffered an electrical failure between the starter, battery and alternator. A wiring loom has been damaged as a result of the oil leak so also that entire part had to be replaced. No trouble since a year on 😉

I have extended warranty all component cover and VW group accepted liability as a known issue with these engines (I think it was also the influence of the service advisor). I only had to pay £100 excess and £120 for new timing belt kit, £220 not worst car bill.

My Skoda 2017 Fabia 1.0 999cc DSG is £180 a year to tax, how come a 15 plate VW polo 1.2 with higher emissions only pays £20 a year and it never increases?

We all know classic cars have soared in value and may or may not be an investment but instead of Petrol, is there a market for old school diesel's, wait for that amber glow plug light to extinguish and a hard crank of the key. In the 1990's and following 80's the French had huge market share in Diesel's both PSA/Renault throughout their model ranges and many other car manufactures used PSA engines. A less common Diesel which If I remember correctly stood up well against the French in regards of reliability and fuel economy of the day was Fiat's 2.0L (1929cc) unit. An extremely rare Italian classic I'd consider owning but unlikely to find one is the Tempra which ran from 1990-1996 and wasn't a big seller on the UK market in it's day. Only 129'000 were made total across across the world so not a big number all in.

hi all, I now only have one working keyfob for my vehicle as one has completely failed and does not function, no red led, It's not a dead battery, that's all confirmed. The key will still unlock the vehicle manually and start it. Skoda told me its £200 upwards, talk about the cost of car parts. I've found plenty of used fobs for my vehicle often from scrapped cars. On my key there's a retaining pin to allow you to transfer the key blade to a new fob and the owners manual tells you how to sync the remote locking. The issue is the immobiliser chip, how to get the replacement key programmed to the car, does it require specialist equipment or can the chip be removed from the dead fob and also transferred, if the chip is built in, can the previous chipped key be deleted from the vehicle as it's no longer needed?