Kenclarke

Yea battery is fine over 12v and not droppping when load applied

Does anyone know what the emergency start procedure is? No power or lights to dash and not starting when turning key. Trying to scan codes but getting messages that ignition not switched on. I was looking on Ross tech site and it seems there’s a procedure where you operate some things at same time or in a sequence like hazards, brakes or wipers and it fires the ignition up so you can read codes. But can’t find what procedure is, anyone know?

Has anyone got an ignition wiring diagram so I can try to follow my problem its on another post of mine. No ignition or dash lights when I turn key. Thanks

Just replaced all the relays this morning, still no ignition. I have checked ignition switch to prove its ok and all is good with switch. The car locks and opens from fob, the hazards work and electric seats work. But anything that requires ignition is dead. When fault first appeared and I unlocked car with fob the headlights would come on and radio would light up. It's not even doing that now, it's like its got progressively worse. Battery voltage still ok at 12.2v. Tried Delphi software but wont read anything as saying ignition needs turning on. Any ideas anyone?

Any ideas anyone, I'm suspecting faulty ignition switch now. Turn key and nothing, no lights or anything. All fuses are good.

Got a 2010 tdi 4x4 estate. Replaced heated seat relay and a couple of interior led bulbs. Came to start car and nothing. Car opens and locks with fob but no ignition lights when switched on and not starting. Battery good and all fuses good under bonnet and interior fuses good. tried to swap bulb in glove box but didn’t have correct led bulb. Wouldn’t start after this. I tugged bulb holder out. Are the relays behind glove box on rhd car. Maybe I could have dislodged a relay. Or any other ideas would be appreciated