Skip to content

drjaking

Finding my way
  • Joined

  • Last visited

  1. This figure seems to agree - this is from a different bit of the manual and looks like the lift is in from the sill seam. So I read that as meaning the sill weld is for short term jacking, eg for a tyre change, while the adjacent part of the subframe behind that is suitable for lifting during maintenance. I will use a bit of carcassing timber between the axle stand and the car to spread the pressure. I don't really understand what the plastic cover and the rubber bungs are about but they seem to be located just where the lift would go in this diagram. Seems an odd thing to do because the plastic cover would get mashed if it's not removed.
  2. Intuitively that makes sense, but the workshop manual is very strict about not lifting it anywhere else! Which is why I've come here. 9.3 Raise vehicle Raise vehicle with a lift platform or a workshop jack The vehicle must only be raised with a workshop jack in the indi‐ cated jacking points -arrow A- and -arrow B-. a = 12 cm b = 24 cm The jacking points are located at the stiff joints of the bottom side rail.
  3. I know others had this problem, but can't find a definitive solution. If I jack up the rear of the car using the reinforced sill-weld, I then have nowhere to put an axle stand. I'm reluctant to pick a suspension member, not being confident it won't get damaged. I noticed just in from the jack points there is an oval plastic cover that comes off and reveals two circulare rubber bungs a few cm apart. I have seen elsewhere someone jacking a Tiguan on this zone using a block of wood as a spreader, saving the sill weld for axle stands. Is this good practice? Thanks!
  4. I think my V425 flap motor has failed. Aircon doesn't blow, but unconditioned air does. I have an error code 329476 in OBD. Also 263425. Both can be cleared but 329476 returns immediately. Looking at the manual, on a RHD Kodiaq it involved removing the whole dash, which looks like a professional job to me - airbags involved. Anyone replaced an aircon actuator themself?
  5. I just found exactly the same problem on 18 plate Kodiaq 1.4. Another of the bolts was coming loose as well. Remarkable. Would thread lock be appropriate here?

Account

Navigation

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.