BlazZzVRS

Yep i guess i will have to get used to this steaming when the car is cold :) I I just thought maybe someone figured something out for this car to drain excess water. I have read on net that some cars have drainage holes on mufflers for this but i didn't find no holes on this car. I will not drill any holes without knowing for sure that this would help and that it's ok for this car.

Hi, Has anyone ever figured out where the problem is with this smoke? I have this smoke under full throttle to with Octavia VRS 220 TSI 2014 manual. When its cold outside Its stops smoking when i really warm up the car like driving for 1 hour or more and when its warm outside it takes less warming up to stops smoking. Must be some bad design in stock exhaust so it collects to much water (no drainage?). I had car in service and they did some testing and didn't find nothing wrong with the car. I mostly do short trips so i know i'm collecting some water in exhaust, but i had Audi A3 1.8T and Audi TT 2.0 TFSI before and did mostly short trips to and they didn't smoke so much on full throttle. The coolant only needs to be topped up minimally on yearly service so i think that's not the problem. The car works well without any loss of power. Has anyone tried to make some drain holes in the mufflers? is that bad for the car? If exhaust is collecting so much water its gonna rust from the inside.

Did you change Dimmwert to 127 for both to? Leuchte28RFL LC11-Dimmwert AB 28 set from 100 to 127 Leuchte29RFL RA64-Dimmwert AB 29 set from 100 to 127 Do you have to change Dimmwert to 127 for LED?

Hi, I im trying to replace reverse standard bulbs with non-Cambus LEDs. I dont want Cambus because they heat up. I have searched this forum and googled and havent found direct instructions for the VCDS coding i need. I have found that i need to change Leuchte28RFL LC11 to 43-allgemeine LED and Leuchte29RFL RA64 to 43-allgemeine LED but i dont own a VCDS and have to borrow it and i need direct path to these settings. After a lot of searching i think the VCDS setup should be like this: 09-Cent. Elect. / Security Access – 16 (code: 31347) / Adaptation – 10 Then you search for: Leuchte28RFL LC11 and change from 18 -2*5W to 43-allgemeine LED Leuchte29RFL RA64 and change from 18-2*5W to 43-allgemeine LED Dimmwert AB 28 8 and change from 100 to 127 Dimmwert AB 29 5 and change from 100 to 127 Do you have to change dimmwert from 100 to 127 for both? Like you have to change ENG116961-ENG116352-Leuchte25KZL HA59-Dimmwert AB 25 from 100 to 127 for LED licence. Can someone confirm that this is correct path and changes for reverse bulbs change to non-Cambus LEDs for error free?