Hi Everyone -
So I finally got around to replacing my start stop button on my Superb MKIII (2016). After ordering the part from my local VW Group dealer ( I just have a local garage here in Switzerland that deals with multiple manufacturers), and with the instructions from TasMan above, it took me all of about 12 minutes. The part was 85 bucks or so.
My personal situation with the button was ... frustrating. Some of the time, it would go first touch, sometimes, on the 3rd, and sometimes I would have to press it multiple times at multiple different pressures to make it work. If ANY of the prior are happening
to you besides first touch, I would HIGHLY recommend replacing the switch. Once replaced, it was night vs. day. The sun shone brighter and the birds sang louder. A bit of drama, I know ... but I tell you what ... it was really amazing how it works when it works well.
I know very little about cars aside from replacing wiper blades and filling up the gas tank - for me, this repair was not complicated at all.
Follow the above directions from TasMan - the following were some things I noticed when replacing:
- Having a little plastic wedge or something non-metal to separate the top and bottom plastic makes the job super easy (TasMan mentions this above, but its REALLY important you don't use something metal to wedge the plastics apart)
- If you have the steering wheel at 0 degrees (i.e. front wheels are pointing straight ahead), you will not be able to access the screws after you pop the plastics apart. You need to turn your wheel to the right or left, this will open up the space to unscrew one of the screws, and vice versa for the opposite screw
- Once the screws are out, the casing just kind of falls down/apart unless you have the lever for the tilt wheel at the top ... you will want to loosen this (i.e. push it towards the pedals) as mentioned above
- To pop out the cable from the button itself, you will notice a small lever / pedal on the back of the cable unit that connects INTO the button (it moves up and down a cm. or two when you push it) ... you will want to take some tweezers or something small to push that lever down, then grab and pull the cable unit straight back
- To pop out the button, you just push on the butt of the button ... hard
May sound like a bunch of instructions and steps, but when you're done with everything and have entered into haptics heaven with a new start stop button, you will look back at what you did and say to yourself 'uhh ... that was not so bad'.
Good luck and all the best