gcasey

Hi all, so just a final word on this topic, I have put about 1k miles on the clock since getting the crank shaft position sensor replaced. Fuel economy has also dramatically improved. Both the position sensor and Reluctor ring was replaced. I hope this information helps anyone with a similar problem. Again thanks for your input.

@nta16so the codes were sent to a vw technician, and he has advised that the crank shaft position sensor now needs to be replaced. I believe that means dropping the gear box to fit. Original it was just the read sensor replaced. I have also discussed with them about the battery and the possibility of it being an ABS sensor also. At the minute I'm at the mercy of the garage, as the car is still under warranty. I really appreciate your feedback. I will keep everyone updated. Thanks again.

Thanks nta16, Still waiting on a response from the garage, they told me they sent the codes to VW, I've called this morning and still awaiting a response. I will be sure to pass on this advice.

Thanks again thamestrader, the garage uses the snap on diagnostic device. I will be sure to mention all of this tomorrow when I leave the car in for further diagnostic and repair..

Thank you for getting back to me, it's not the first time I've been told it could possibly be an ABS sensor issue, however after the crank shaft sensor got replaced, these are the error codes. Image attached. I asked the technician was the new sensor calibrated/paired to the car. Was told no its just swap out and replace. I will keep you posted on progress.

Hi I'm suffering with this problem also, I have just bought the car 3 months ago. This issue developed about 6 weeks ago, oil temp was about 75 degrees, all of the same errors appeared, including tyre pressure, no start/stop, front assist etc I was coming out of a roundabout at the time and felt like the brakes had been jumped on. Lucky enough no one behind me. I took the car back and was told dirty fuel, i drive quiet a bit but use the same station, so dirty fuel was ruled out, the errors were cleared, every trip there after same errors appeared. Took the car back and they replaced the crank shaft sensor.. Took it for a spin and same again errors reappeared.. Once the car is warmed up fully, I don't have this issue. Anybody any answers that could help.