Jscobie

Finally managed to fix my heating, Some idiot had fitted a left hand drive fan which has the vanes orientated in the opposite direction. In typical skoda fashion now that that's fixed the matrix appears to be blocked also

Hi scanned the system an no fault codes to do with the heating system, For the small amount of air that comes out I can adjust between hot and cold which indicates the hot cold flaps are working each side, I can also direct it to the windscreen and to the centre vents on th dash, th fan operates on all settings but sounds loud and kind of muffled, I can use the car with just me but any more and the little air that comes out can't keep the windscreen clear. I think I have no option but to fully remove the dash

Hi guys I have the same issue with very little airflow regardless of setting on the climatronic control, replaced the g263 sensor yesterday and still no change, I have visualed all servos cycling so I'm starting to suspect a broken flap or an obstruction

Hi I have the same issue did you manage to get yours sorted? I have ordered the g263 sensor in the hope that it will cure the issue.

Hi new cabin filter installed, I've ordered the g263 sensor as I've read similar issues which this has fixed

Hi guys I'm having trouble with my heating, the fan can be adjusted from 1 to 5 with no issues apart from being very noisy and I'm getting very little airflow from the vents but I can select the vents OK, having read similar issues I've ordered the g263 sensor but I'm unsure where it is? Does it require the whole dash out or is there an easier way to locate it? TIA

Yes I have done it correctly, I had the glove box out at the time and could see the servo / white rotating back and forth and also had removed plastic vent for footwell and was able to visual 2 flaps moving, think I'm going to have to remove the dash and strip the heating system down to look for a blockage, or an actuator control arm not on correctly

I've tried recalibration several times but no change

Hi I'm having a similar issue, fan up full and only a trickle of air coming out whichever vent is selected, I'm assuming that the directional flaps to each chosen function are working as when you select one you do get a very small amount of air from it, is there a flap before any of the selectable function that should open when the ignition is turned on? Also the fan sounds way noisier than it should be as its not getting a clear path, had the fan out and ran it up no issues with the operation of it. I'm getting a little stuck with this, any help would be greatly appreciated