epasha

Hello everyone how you solved this problem The car is Shkoda superB 2004 year engine- AWX the car came with a problem in the driver's airbag on the steering wheel with a broken ribbon cable.I put a 3 ohm resistor and the airbag lamp went out but the ABS module light came on.I tried to connect a vag com to the ABS module but there was no communication.It turned out that someone before me had dug into the car and the cable for the k-line was cut and cut in the dashboard and from the dashboard there was a new cable connected to pin 7 of the diagnostic socket.the ecu of the car could not communicate with the ABS when I opened the socket of the ABS module someone before me had cut the k-line and would be soldered again. ABS Controller: 3U0 614 517 D Component: ABS/ESP front 1314 I cut the cable in the socket of the ABS module and passed a new cable to 7 pin of the socket for diagnostics and communication was restored but the module had lost the encodings Address 03: ABS Brakes Controller: 3U0 614 517 D Component: ABS/ESP front 1314 Coding: 00000 Shop #: WSC 00000 3 Faults Found: 00778 - Steering Angle Sensor (G85) 66-10 - Not Matched - Intermittent 01044 - Control Module Incorrectly Coded 35-00 - - I tried to encode it in the lunch and VAG COM but i don't know the original encodings I do not know the original codings, I tried with those that suggest VAG com Login 09555 Coding 04255 but but I don't know where to find the WSC coding I wrote WSC 12345 the car accepts the coding but after switch off the ignition key and switch on again the car loses the coding Coding: 00000 WSC 00000 the car loses the saved settings and I have no idea how to fix the problem. Can anyone help solve the problem.