Hi all, hope you can help!?!
Looked on Youtube, the web, etc to find help in replacing the resistor bank on my recently bought Roomster 2014.
The heater works on number 4, but not on settings 1-3 (a common fault I'm led to believe).
Most videos/information refers to other models of Skoda...Octavia etc
My Roomster model has the double glove compartment. There is NO passenger airbag disarming keyswitch.
I have managed to remove the upper compartment and I can see the three screws that hold the passenger airbag. (I didn't have long enough Torx keys/allen keys to go further and attempt removing the airbag at the time!)
My queries are, before I 'go for it'...
1 Should I have to disconnect the battery before I start (and if so, will I lose the radio/code)?
2 I've read that there are clips on the airbag to be 'popped' before pushing the airbag up onto the dashboard.? Where are these located (Picture attached). Do you push/pop/slide these clips?... and does the airbag need prised out or lifted out in a particular way?
The airbag sitting above and behind where those three screws are?
3 Will there be enough length on any cables attached to the airbag and plenty of room to get to the resistor bank?
4 How sensitive do you have to be when handling the airbag?
Any other information regarding the difficulty in getting the job done would be most welcome.
Thanks, in advance, for any help!
