Grit

Hi guys, i hada similar issue with my trunk opening only 1/3 of the way. I had replaced my struts as they weren't lifting up. (Confirmed fault codes for right hand strut) so replaced both as I don't like doing one side only to have the other go a short time later. I then fitted new struts and noticed 70% of the time the trunk lid would only open 1/3 of the way. I noticed I was getting "6d trunk lid module" fault code. "No basic settings" B201000" T For The 2 settings one was "zero inclination angle" and the other "adapt flap opening angle." For adapt flap opening angle, Every time a hit the "adjust", nothing happened. So i then tapped "adjust" and with the trunk closed, I tapped the open button. I could tell it was in learning mode as the audible sound was different. But when it got to the top it would make the fault sound and i couldnt close it with down button. Had to manually move it down and close. (This was all done on level ground; at least I thought it was level enough.) I then found perfect level ground and carried out the same request. Hit adjust on scanner. Then tap open button on trunk lid, (again audible sound confirmed it was in learning mode). It Got to the top with no fault sound. Hit the close button and this time it closed with learning sound. Once the trunk lid shut the scanner said adaption finished. I then went into setting "zero inclination angle" and it also said adaption finished. I was then able to clear fault code for basic settings and what do you know. The trunk opens perfectly now. (Apologies I never took screen shots. Was in to much of a hurry to get it fixed.)