major-eyeswater

Would both sidelights be on the same fuse?

Ive got warnings for both left and right sidelights being out. These warnings came on at the same time. Both sidelights appear to not be working, but why would they fail simultaneously? Thanks.

I see, that's a shame... How would I get a cable through the door grommit, I assume it's two electrical plugs connected together, is there room for a rogue cable?!

AHH, understood 👍 But, isn't there a switched + in the doors , one I can tap into? I'd rather not have to run a dedicated feed if I can avoid it, I'm not sure how I'd get through each door grommit! I appreciate your help btw

Main module is the main led controller, the kit comes with the main and 4x sub controllers for the doors. The main is piggybacked onto rear wiper fuse and works as it should with ignition on. The doors, I'd planned to wire to door handle light, it's a switched + when you unlock the doors. The issue I'm having is that the fusebox live, and the handle lamp live, don't energise simultaneously, and it upsets the led modules. It's as if the main module cannot 'see' the sub modules.

Aftermarket, but having issues. The main module has been wired to a switched live from the fusebox, comes on with ignition, dashboard led strip works as it should. I intended wiring the door led modules to the inner door handle bulb, it's a switched live from when the doors are unlocked. But, the door module won't respond to the trigger from the main module, I think they both go 'live' a few seconds apart, and they don't like that!

Much appreciated, thank you

Simples, if you know the right people !

Anyone have a wiring diagram for the drivers door loom, pretty please?! 2014 mk3 vrs

Yeh vrs tsi. For the price, 100 fitted, im pretty happy. Deffo does give it a nicer note!

I went for this: ZaustworxSkoda Octavia VRS MK3 Resonator Delete PipeZaustworx centre silencer delete / resonator delete / deres pipe designed to fit the Skoda Octavia VRS MK3 standard factory oe exhaust system. Sounds a lot raspier on startup, and a little through the rev range. No negatives yet!

Yeh I did it. Sounds a little nicer, no drone to note.

Hi, Anyone know of a switched live in each of the doors, behind the door panel? I'm fitting ambient lighting and need a switched pos in each door. Ta.

2014 2.0 tsi. Car was stood for 2 hours, then a few minutes after starting up i got the epc light, dont exceed revs, and temp needle almost in the red, also cooling fans were on high. I stopped for a minute and restarted, and the error did not occur - have done a quick scan and comes up with: P00B7 - Engine Coolant Flow Low/PerformanceIt did have a coolant flush and new temp sensor recently, the one near the radiator. Does this sound like a glitch, or worth investigating? Thanks.

So, the garage are having issues bleeding the system via software. Fans are coming on early and the system isn't getting to temp, they have suggested a coolant pressure test... Anyone any ideas what could be going on here? It's been scanned but it doesn't throw anything up. I literally changed a leaky pipe, but lost a lot of coolant in the process - I refilled as I thought correctly, bit obviously not. They've had the car a week and I really need it back.