TonyW1967

Thanks, I guess we just need to run it more often - I did add cleaner additive a few months back (to a full tank), so we'll get it on the open road.

I don't mind doing that, but the car starts first time, every time, so does it need replacing?

I wouldn't know, the car has 146,000 kms, and we don't know the service history prior to last year.

To be honest, the smoke isn't that bad, it's not blue or white, IMHO it's probably nothing to worry about - it's driven very infrequently which doesn't help, but that will change soon, so we'll take it to a local garage for summer tyre fitment, and get them to check it while it's there.

And to check error codes, I would need the VAG OBD system?

Thanks both, good points and will follow your guidance! :-)

I don't believe it is blue or white, I just think it is excessive - if I had to put a percentage of 'how' excessive, I would say 25%. We haven't really driven it much TBH, my son is taking his driving lessons, and I don't use it much, so I can't say how much oil it uses. And no, a compression test hasn't been done - we don't haven the equipment to do that, but it is something that we may get a better equipped friend to do in the next couple of weeks.

So, potentially into phase 2 of the Felicia Combi project! Currently we're mulling over starting the following; Replace the temp sensor Throttle body clean (although I don't have the equipment to reset the ECU) Removing all breather hoses and checking for blockage Next though, we're considering valve stem seal replacements - has anyone done this? How easy/difficult is it to do? Any other thoughts on how to minimise smoky exhausts?

If anyone has specific pics of the process/location to splice, would appreciate it

Hi All, has anyone fitted one? I've just fitted a basic DC12V system on the rear, and am wondering where to connect the power (without causing any drain).

Just done the basics in the engine bay, will leave that for the boy. I managed to get my hand on a set of steel wheels with summer tyres, that aren't too old, so we've spent the day cleaning them, rubbing them back, getting rid of rust, and priming them - tomorrow we'll buy some wheel paint to spray them with.

So, just finished the first stage of the Skoda Felicia project, inside immaculate, outside all rust repaired and sprayed, now have to wait a few weeks before orbital polishing! Should be completely finished about the same time that my Son passes his test! 🙂

Yes

I managed to get my hands on one, which was fitted to a bumper, but I broke it when trying to remove it - how does one remove it without damaging it?

So, just replaced the seal, easy to fit! Excuse the mess, I'm re-using the paper for spraying purposes! 🙂