I have just disconnected the touch bar/volume slider using the instructions from this forum. So far it has fixed the issue. If it helps the exact steps I followed were: Remove long trim piece underneath screen. Start from the edge of the passenger side and pry the trim upwards. Each clip will then release with a bit of pressure. Remove the cover from the rear of the screen. This for me was the most difficult part. What worked was to gently pry one of the edges up and rock my pry tool up and down slightly until it unclipped. Unscrew the screen. 4x T20 screws holding it to the dash. Pull the screen forwards and tilt it down to gain access to the back. Unscrew the metal back cover of the screen. Without disconnecting anything, move the metal cover back and slide towards the dash along the cables. I.e. do not disconnect the two cables. Ensure the radio is currently playing (i.e. screen and media are ON) With the radio playing, identify the touch bar power ribbon using the images in this thread. Flip up the black catch holding the ribbon in and disconnect the ribbon. Ensure the radio is still playing and screen is still on. Reassemble Hope that helps!