a65rocket

Open your sunroof There should be drain holes at the front corner Clean any muck away from the hole use a length of wire (1.5mm electrical wire works for me) and plunge it down the hole to clean it The exit for the hole is a rubber gromit half way up the door piller. To dry your wet floor use lots of towels, I ended up removinf the swab from underneat the carpet and drying it over a week, however this meant removing seats and trim.

I could be interested in the RNS315 if Cheekyfork doesn't want it, does it come with the DAB ariel as well, and the Sat-Nav receiver ?

I now have it working, the initial bit in the Coding then allowed me to select the Hill Hold assist in the functions section.

I had this problem with my 2010 Yeti, it was the way I twisted my body before exiting the car. It caused the seat belt web to wear. Skoda replaced the seat belt

Fabia III (16 plate) I'm trying to enable Hill Hold on a Monte Carlo I have set the below bit to 1 (Far right bit within Long Coding), changed from CA to CB It does not seem to be working, is there anything else to set, I have noticed in the Functions section of ABS that there was a Hill Hold Assist option as well. HILL HOLD CONTROL - ECU03 (Brakes) - Coding - Byte 22 - Bit 0: enabled (Default: disabled)

If his Yeti is on variable servicing, then ITS NOT annual.

With a full sized brolly in there, it supports it, but goes clunk, clunk when driving over bumps. I don't use it now, its still fitted though.

I have had 2 Yeti's leak, but it was the drain hole getting blocked by plant debris. I too have had to dry out the inertia, those floors do hold a lot of water don't they.

I too changed from a 170 TDI to a 1.4TSi petrol but with manual gearbox Sunroofs, I have 2 leak due to the drain holes getting blocked by fine debris. I use a thick wire (2mm) from the top holes to ensure that the drain holes are clean. Also the rubber trim gets a bit hard so use a rubber restored (Gummi something) to keep it supple

Sunroofs, I have 2 leak due to the drain holes getting blocked by fine debris. I use a thick wire (2mm) from the top holes to ensure that the drain holes are clean. Also the rubber trim gets a bit hard so use a rubber restored (Gummi something) to keep it supple

Open the drivers door, the shiny plate on the door step should say "Business"

Where did you get your wiring loom from (ebay reference ?) I did get one from a Golf which piggy-backed from the TCS button, but the wiring was different. I have a Yeti TPMS reset button which I brought from Skoda (£7) cheers Andy

I have towed our Hobby 560 caravan (weight=1500kg) with both my Yeti's, the only hassle was the extra width of the caravan needing WIDE mirrors. 140 4x4 and the 170 4x4. No problems except on a flooded field when a tractor had to tow us off. Sits at max speed 60 fine, with mpg=29. Just look ahead and brake steady (basic towing theory)

They say that it will fit an RCD510 (Bolero), what fitting instructions did you get ?

My previous Yeti did have park assist, I used it twice. With my new Yeti, the dealer forgot to add the front sensors, I have looked at it, you need the additional front sensors, an 8 port controller box (located in the RH rear wing), and an additional parking bleeder with a different tone to the reversing sensor. I have a VCDS cable, and it looks like you just tick the front sensors option on. There is a Park Assist check box, but I don't know if it requires an additional module. Let me know where you sourced your sensors & cabling, I keep looking at eBay. Andy