Panosm

Illegal.

Yeap.

https://www.dropbox.com/s/cvae6yaerrh7qsr/Photo%202013-01-24%2019%2007%2014.jpg

I have the black pack as well but with 4 h7 bulbs..

I suppose you opened the hood and checked it? http://carlook.net/data/db_photos/skoda/fabia_rs/2nd_f/skoda_fabia_rs_2nd_f_hatchback5d-945.jpg One in projector and one besides it. This is true If not skoda decided to change the lights for 2013.........

Not true. It depends if you have the FL fabia or not. The facelifted fabia has two bulbs per side. One for full and one for dipped.

Mine did the same. Warranty job. Was told they changed the mounting brackets.

The swing does work with bt. Pretty sure that others who have retrofitted bt did buy a harness that was plug and play along with the module. I would recommend you guys to do the same. Carsystems.pl surely have that kind of harness available.

Mine do not lit up after ignition on and never did. They are on on the second and third (dipped on) step on the light switch.

The mic pins should be attached to the current loom. If you're handy with soldering you could do that yourself, but first google it up which wires you'd have to fiddle with. I got my kit from carsystems.pl that included an "in between" loom for plug and play.

See last post for pictures, http://www.briskoda.net/forums/topic/239259-how-do-you-enable-mfsw-control-for-bluetooth/#entry2985124

No and no. You could hunt down a couple of osram 65w, but those are only for off road use.

I have a Columbus unit in my mk2 vrs and it works without any glitches. Just needs some vcds fiddling and you're good to go.

Think I've seen some of those (replacements) on sale at eBay.

My whiteline rarb did that too. After I dismantled for closer inspection I relubed all the bushes with silicon fat (not sure if the translation is correct). However it didn't stop the squeaking. I've found that the rear door rubber sills made the noises. Add some lubrication on those and you'll be fine.

In Stockholm we have about 20-40cm snow, never an issue with the dsg. The snow/ice driving was even better than I expected. No need for jumping onto 2nd gear, 1st gear and foot off accelerator does the trick if getting stuck.

You need 11.13 for complete access to your Bluetooth module. Seeing the bluetooth module in vcds is not the same as having it ticked in the installation list.

No

I've done about 17000km and added about 3l oil total - 1l x 3 times. Topped it around 16000kms and when I checked yesterday it was in the middle of the crosshatched markings. Hrmmmm....

Mpravo patrida, ola super fenonte! and a sort-of translation of the above; "Looooking good!"..

sry, don't not know where you got that info for the 1.4 tsi. While it is true for 1.2 to check the oil when cold, you'd have to run the 1.4 tsi for a while to get the oil up to temperature and then wait 10min or so to check it. Not a few hours... Time to open the owners manual at page 164 and have a look.

I don't get it.. Why shouldn't plasti dip protect as much as vinyl? In that case I'd be worried to even wash the car..

Wish I had two more thumbs, so I can give it.. 4 thumbs up.

So they are basically there to counter the drivers weight. I might be reaching here, but they could be there to - as told before; not getting the ass to far out.. what about not only side to side movement but also making the back of the car less "jumpy". Equal dampness in the back as well in the front.

Are the weights only installed in rhd and not lhd cars?