Skoda Octavia mk2 pre-fl headlight washer retrofit

[CiprianT]

Hello!

Well, it took me almost 2 days until i have convinced myself that i need help.

I had a crush with my Octavia 2 from 2008 pre-fl model, all front was crashed, not hard, but enough to change many parts.

I have convinced myself this way to add some new features to the car as i have her all disassembled in the front, so I've added water sensor for the windshield washer and a new bumper with headlight washer.

All right, i have figured with the water sensor, i will install it today in the IC with cables from the sensor till the IC 34 pin for + and 33 for - and the VCDS coding.

But i have big missing information for the headlight washer electrical installation.

This is what i have: All hoses installed, new pump on the water recipient, bumper with washers, i have cables, i have found the relay location (MEYLE 100 951 0001) under the steering wheel and soon will be installed. OK i guess one cable will go to the relay, i guess. But what i will do with the 2 cables? Where i install them?

 

Those are my questions, i didn't find anything in my country or here as this is the biggest community for electrical installation for windshield washer.

 

Did someone retrofit this? i think it is not that hard but i don't find any schematics for this sadly. (i have found some electrical schematics but i understand nothing from them)

[nige8021]

This is the wiring diagram from the dealers manual

 

So you will need to install the relay (D5 in the picture below) and the two wires from fuse # 36 a wire from the relay to the onboard power supply unit under the dash to pin 8 of the 11 pin brown connector and finally a wire from the relay to the washer pump