Skip to content

PD 130 Crankshaft Position Sensor cable routing.

Featured Replies

Hello Everyone,

 

Can I re-route the new sensor in front of the oil cooler housing as I cannot get the plug or sensor past it and think I will have to cut out the old one? 

 

 

 

 

 

 

20250109_203535.jpg

20250109_203406.jpg

  • Author

I think I have found an answer to this question. The oil cooler has to come off as I cannot get access to the sensor bolt anyway... The cooler pipe is in the way... 

 

So I won't need to re-route as can fit properly after getting oil housing off. Guess I need a new gasket? 

 

https://www.briskoda.net/forums/topic/184320-octavia-ii-19tdi-pd-engine-speed-sensor/#findComment-4440290

 

Fault code is implausible signal and wiring looks good so pretty sure it is sensor failure. Original 12 point bolt, not been replaced. 

 

Anything I need to be mindful about on this? 

  • Author

Update I used a combination of 12 point 3/4 and 1/4 sockets and extension bars and the housing is now off. Bottom right is the most awkward...Also removed speed sensor ready to fit new part.  

 

I understand people reuse the bolts despite guidance to always replace... but what about the gasket. It looks undamaged imo. I guess not worth the risk for the cost. 

 

 

Create an account or sign in to comment

Recently Browsing 0

  • No registered users viewing this page.

Account

Navigation

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.