rover220

Yeah that will surely show them.

Yes that's obvious, any machines used in these places won't refill if there's a leak.

i dont think so, ac works well. i would have to get it checked again to be sure.

should have added that i already had it gassed. was down at 300g and now has approx 525g according to the print out.

Hi folks Suspect I know the issue here but always worth asking. The aircon on my 1.4tsi yeti more often than not causes the engine to whine and feels like it's under quite a lot of load. Whine is very audible between 1.5k and 3k rpm and stops if you turn the ac off so it's definitely that. I suspect the compressor but any other thoughts? It blows cold and works well though.

All fitted and coded.

So I managed to get a fitted but never used westfalia from ebay for £135 and an ecs 13pin kit for £107. Will fit this weekend, very happy with that.

Can be programmed to work like this with vcds

@pab567 seems you are the man for updates, i have mst2_eu_sk_pq_p0241t is there any better versions to run? can this unit have android auto enabled?

Would rather fit myself. Not a difficult job.

They do kits for without prepared connector https://www.ecs-electronicsuk.co.uk/en/towbar-wiring-kits/sk015d2u.html

I'll be doing the electrics and coding it, did my Mk2 superb and assume the yeti will be much the same. Looking to use the ecs wiring kit which looks like it'll be full 13pin spec.

I'm looking to fit a detachable towbar to newly purchased yeti, seems there are 4 main choices. Westfalia, brink, thule, pct and tow Trust. Any experience for or against any of them?

didi you really do that whole job using the cars widow maker jack?

you wont be getting an impact wrench near them.