stanian

I used something like these,but mine were single sided and 1 large LED, can't seem to find them now. https://www.ebay.co.uk/itm/2-x-501-White-1-sided-one-5050-smd-led-footwell-under-doors-interior-w5w-wedge/263351400546?hash=item3d50f77862:g:NEIAAOSw0exaIBDv

Rear number plate LED Controller 09 - Central Electronics -> 16 - Security Access - enter 31347 -> 10 - Adaptations (1)-Leuchte25KZL HA59-Lasttyp 25 - set to: 43 - allgemeine LED (6) Leuchte25KZL HA59 - Dimmwert AB 25 - set to whatever you need to adjust brightness, having said that some Led's will not dim, they will just stay the same until they go out.

I bet it would cost me in petrol to get to my nearest TPS.

I have found that all of the Bosch blades I have ever fitted have only lasted five minutes, I am not a fan. I have taken Bosche blades off after less than 6 months and very few miles as they have been juddering and very noisy. Buy cheap buy twice. Original replacement Skoda blades have now been on well over 12 months with no issues. The fronts. https://www.theskodashop.co.uk/products/skoda-front-wiper-blade-set-octavia-iii?_pos=4&_sid=f21c01525&_ss=r The Bosch also have a different size for the passenger side about 25mm longer. The rear. https://www.theskodashop.co.uk/products/skoda-rear-wiper-blade-octavia-iii?_pos=1&_sid=f21c01525&_ss=r

I enabled it on my 65 plate tsi with Carista, you either have to have the subscription or like I did did it in the free subscription period. I have since bought OBD11 though, HBA works fine.

Coming back from Cornwall today, I noticed the temperature in the car was getting quite warm, so I checked the climate control and set it down to 17 degrees. The fan speed went up but the air was not blowing into the cabin and the car cabin temp just got hotter. Quite a few miles further on there was a change in the fan note and the air started to come through and has been ok since. This did happen before funnily enough on the way down to Cornwall last year, it was raining and the fans were not clearing condensation from the screen because no air was being blown through. it was as if a flap had not opened or something. Was going to look for a fault code with OBD Eleven but got an error message on that "device is not Authorised" Only had the OBD eleven for 2 months, not happy with it. Anyone had anything similar happen or any ideas? thanks