fabioso123

I'm much the same, sealed doors up and left the door cards off and could see water dripping down from speaker. Removed speaker to watch again. Just need some more rain now.. which shouldn't be long. I thought to maybe silicone speaker surround in but you say yours was already like this and still leaking so unsure.

Reviving some of your knowledge here on front door leaks. Door card removed and can visibly see. Water coming down from front door speaker. Removed speaker and can see it dripping from above. Are the speakers meant to be sealed in like the rest of door internal to keep any drips on the outer side? Cheers

I did think that, they seem to be all sealed up. Carpets always been dry too. Maybe worth resealing them. Cheers folks

Would I be better off asking where the damp smells coming from then? Ha

When washing car, small trickles of water running down the rear windows (on the inside btw haha), pointed me towards the seal. Thanks anyways though!

The big chunky seal, no idea what it'll be called haha. The front two have splits in them so was just going to change them all. Rear doors do let water in at the bottom of the door. Well there's water sat on seals below door when open them not sure if it's coming from somewhere else and just sitting there.

I've needed new door seals for some time now, not in a mad rush and not done much homework... Clearly. Does anyone have recommended suppliers or can point me in right direction? Dealership told me they were discontinued in 2018 and I'm not convinced on the seals i have saw on other websites. I'm not wanting trial and error of buying online, trying them out and returning them if they don't fit. Recommendations would be much appreciated. Thanks

It's not been started but has been moved since. Yeah it must of been throwing out at the start but I couldn't tell. Yeah someone mentioned it maybe wasn't starting due to crank sensor or something. Was just making sure.

I did, 12v was there. I've got a new starter coming to rule that out anyway. The right one this time hopefully. Cheers

New starter came from ebay.. (wrong starter came from ebay) already removed original one from car. Tested it again outside car with battery and it fired fine no matter how many times I tried it. Refitted it, nothing. When turn key back to off position can hear the splined drive falling back in to casing so sounds like it's doing it's thing. Could the crank position sensor or something be causing problems?

Put 12v straight to starter and nothing. Will get new starter unit ordered. Cheers

Tested wire of doom and voltage ok, still not starting. Within the new solenoid plug there's a purple plastic ring. Sure it wasn't in the old one? Will I try break it out?

Few years back the infamous wire to the starter had broke, joined it with block connector and worked fine ever since. One night before the hard frost in December the car just wouldn't start. Got power with lights and radio etc but no click when turning key right round. Split and rejoined wire but still nothing. Pulled old solenoid off and tried putting spade terminal directly into the port on to the blade. Still nothing. Was told this should definitely do something but nope. Ordered new solenoid plug but just want to check if anyone else has any ideas? Starting to think it isn't this problem. Cheers