ElliottLW

I think you have to be careful about what you buy, mine doesnt drone at all

I just put a res delete on my 245 and its been brilliant for the 25k miles I've ran it

If you know someone with VCDS or ODBEleven they should be able to code it in easily for you

Can absolutly be adjusted, drove me nuts until i found out!

Nice spec, but as others have said its a 245 exiting before the refresh

It should be pull towards you for +1 and push up/down for +5/-5

What settings did you use as most on the Areca forum have found that it’s random what car contain the module even without memory seats

Hi all, mirror dip only works if your car has the seat memory module fitted

Just for security I would recommend removing your VIN number from the provided ODBEleven export

I've never used credits on mine... Rear DRL's High Beam Assist Traffic sign recognition Diff set to "strong" SS disabled A load more smaller tweaks

This is what I used to code on my VRS245 (18') Procedure: Ensure light switch is off Conduct a soft reset when accepting each change Reset Light menu to factory settings after coding to display new menu option Controller 09 - Central Electrics Security Access - 16: 31347 Adaptations - 10 - Search for Fernlicht to narrow down the options - Menusteuerung Fernlichtassistent Werkeinstellung: Set to PRESENT - Menusteuerung Fernlichtassistent: Set to PRESENT - Erwiterte Fernlichtsteuerung: Set to AFS: FLA: FERNLICHT UEBER AFS Menu option for "Light Assist" should be available in the Lights section of the Car settings menu (may require a factory reset of Light menu). If you want HBA to remain active, with light switch in Auto, then code the following - Fernlichtassistent Reset: Set to NOT ACTIVE Controller A5 - Front Sensor Coding (using experimental coding values) -Byte 19, Bit 0-3 (00 FLA_Additional_High_Beam,no_Additional_High_Beam -Byte 19, Bit 4-7 (20 FLA_Headinglight_Type,LED) -Byte 21, Bit 5-7 (20 AFS_coding_Light_Assist,High_Beam_Assist) Controller 4B - Multifunction Module Coding (using experimental coding values) -Byte 11, Bit 6 (High Beam Assistance,Enabled) You may get an error pop up regarding Headlight Range Control. To clear this, go to Controller 4B, Basic Settings. -Basic Headlamp setting -> Go -Acknowledge basic setting -> Go

Should in theory be able to map to ~300bhp too

I'm not so sure, the units can be purchased for ~£600 which doesnt seem to bad

Has anyone tried to retro fit and been successfully with new LED units?

Isnt there an issue with caliper clearance though? My vrs245 has 345mm discs and they would struggle to fit behind a regular spare wheel.