AndrewRoberts

Oh yea, not hard to add a cut out, style wise they all look the same

All mk1 saloons have the same rear bumper 👍

Be fine mate in the short term, it will throw up a few codes and EML, but won’t effect the performance or the running of the car

If I remember right you need 2 x 4mm and 2 x 6mm for under the inlet, I used one of one 4mm nipples for my boost gauge tho

Mine done exactly the same, luckily it was a couple days before I was booked in for a refurb turbo, so got it done at the same time

There are plenty of VRS breakers on the #ovrsmk1oc owners group on FB

eBay will be your best bet, you will be able to pick a pair up pretty cheap

I’ve now replaced it for a OE one 👍

I bought a Compbrake Diverter Valve last December for my VRS, recently I had noticed a drop in vacuum on my boost gauge it had gone from around 22inhg at idle to about 17, so it indicated a boost/vacuum leak, it turns out that a oring was missing from the DV and it was letting by, I tried to contacted Compbrake but got absolutely no where with them and they were very unhelpful... so now I’m stuck with a useless dv that I wasted £60 on and it’s been over 6 months so I can’t get PayPal involved.... so don’t bother with this company and don’t bother with aftermarket dv’s..... And also, where did the oring end up?? At a guess it’s in my 6 month old replacement turbo 😡

I’m a member of that group, the R32 VRS sounds nuts 👌

Exhaust blowing? I recently had to change my down pipe because the flexi joint had gone and like you it was quiet at idle and i could only hear it when the revs increased

Result mate

Yea they rot out pretty quick really. At least your elbow came out in one piece, mine snapped off in the oil filter housing and was a complete pig to remove

It is now, I also had to change all the crankcase breather pipework and clean the throttle body This is the mess the previous owner owner left for me

Wrong thread