Pitcaig

Hi today I’ve just fitted new rear discs and pads and I used TRW. They look to be good quality better than the last set of rear pads which were Bosch. cheers

Hi I didn’t bother with the heated seats as I would have needed to change the BCM for a high one and I couldn’t be bothered with the hassle and the cost for the new bcm, programming it and the new heater control panel. For the seat airbag wiring if you unplug your seat from where it goes through the carpet then remove the seat. Once removed follow the wire to the base of the seat and you will find another plug. Remove this short length and transfer it to the Audi seats then you’ll be good to go. cheers

Hi I’ve just changed my interior to an Audi S3 leather and have a full black cloth interior from my car that I’m going to sell. It’s in good condition and my car has only done 31k miles. I’m in Falkirk if that’s any good for you? I can also help fit it for you. cheers Graeme

Hi I’ve just changed my interior to an Audi S3 leather and have a full black cloth interior from my car that I’m going to sell. It’s in good condition and my car has only done 31k miles. I’m in Falkirk if that’s any good for you? cheers Graeme

Hi I’ve just done this yesterday with a set of half leather seats out of a 3dr A3. All went smoothly and I only had to swap over the small wiring loom from the Skoda seats to the Audi seats for the seat belt indication. they are also heated so that’s my next project to look into getting them working. Just need to give them a good clean. My wife thinks they make the car go faster 😳😂