lalwong

I cannot open the link

I have the same problems. Need help Did you find the solution and what it was

Thanks, I will check that for sure. Then will go to other steps for fuel pump relay, etc. Thanks a lot. I will let you know the outcome. Have a good night

yes left side is the driver side

Thanks TMB, as I was expecting, this is just a warning and thanks for the video on how to reset it. Now I am up to others issues. Scanner communication that wont read. Is there a fuse that I need to check in order for the OBD2 scanner to communicate with the ECU computer of the car. I still have to check for the fuel pump relay and fuse to see if I can get this car starts. Any ideas,

Hi Samsing, According to the codes P2096 is the the spark that is not working properly. Check if each plug is given the correct spark. May also be the wiring is defective. P0341 is related to the camshaft position sensor. Check the proper voltage or short. You may need to get a new sensor. P0106 is related to the MAP sensor, also check for proper voltage. May need replacement as well. Hope this helps you. Let us know if you fixed it.

I recently bought a a 2004 Skoda Fabia MKI hatchback. I dont usually buy cars that I cannot start and test drive, but seeing the car in good condition I just went ahead. The car was parked since March 2020 due to Covid so battery went dead. I tried with a new battery to start the car and no luck. It cranks, but no start. I even connected my scanner to see any fault codes and is not communicating with the ECU at all to find out what the problems are. I have two scanners and both are unable to connect. One thing I noticed on the dash, is the inspection message is on. Here are the things I need to know: 1. What possible causes are that my scanners are not communicating with the OBD2 port and ECU computer? Is there a fuse that I need to check in order to the port or ECU to work with the scanner? 2. Is the inspection warning signal cause not to start the car? and how I can reset it? I had seen videos about resetting, since I am new to Skoda, I need to know. 3. I am about to check the relay for the fuel pump to find out that is sending the amount of fuel, since I did not hear a noise. 4. Also will be checking if the sparks are working. Any help from you guys will be greatly appreciated. I see a lot of potential in this car. I am newbie. Please go directly to what you read about the problems in the car. I had seen a lot of responses and guessing that do not correspond with what an issue is about. Serious people, please. Thanks EW